Bil, CHERY, TIGGO 5 (T21), SQR 484F - ME17.8.8 (ECM)

Vehicle manufacturer spare part number: T21-3605010AM

Systemidentifikation: 9HP

Stel nr.:

Vehicle manufacturer ECU hardware number: F01R00DH

Supplier ECU software number: C429_G01

Motortype: D4G15B

P0615: Starter relay circuit

P1600: Ukendt fejlkode

P1617: No response from SIM during challenge period

P0443: Evaporative emission (EVAP) system canister purge valve circuit

P0409: Exhaust gas recirculation (EGR) valve position sensor 1/A/single - circuit malfunction

P0120: Throttle/accelerator pedal position sensor/switch "A" - circuit malfunction

P0220: Throttle/accelerator pedal position sensor/switch "B" - circuit malfunction

P0115: Engine coolant temperature (ECT) sensor - circuit malfunction

P0135: Lambda sonde 1, bank 1 varmelegme fejlfunktion

P1666: Ukendt fejlkode

Clear DTC

Maximum torque: 39.6 %

Target engine torque: 7.1 %

Real engine torque: 7.8 %

Motor kølevæske temperatur føler: 15.8 °C

Motor Hastighed: 1156.5 Omdr.

Tid siden motor start: 3495.2 sek

Køretøjets hastighed sensor: 36.4 km/h

Barometrisk tryk føler: 18.1 kPa

Batteri spænding: 1.81 V

Throttle valve relative position: -746.7 %

Intake air temperature sensor: 15.8 °C

Outside air temperature: 15.8 °C

Throttle valve upstream pressure: 36.1 kPa

Accelerator pedal position sensor: 33.2 %

Fuel consumption: 0.0 L/s

Maximum engine torque: 850 N·m

Fuel system status: Data invalid

Relative air mass: 33.2 %

Luft masse måler: 544.0 kg/h

O2 sensor 2 output: -- V

Relative air charge: 33.2 %

Temperature sensor for engine temperature management: 40

Torque path in function and function monitoring as environmental condition of diagnostic: 152

Actual torque at response of torque comparison in the function monitoring: 51.5625 %

Model-based substitute value for engine temperature signal in case of error: 63.0 °C

Target throttle position: 33.3 %

Exhaust gas temperature sensor 2, bank 1: 373.3 °C

Engine coolant temperature (ADC): 15.8 °C

Model-based reference value for plausibility check of engine temperature signal: 39.0 °C

Calculated actual torque in function monitoring: 15.2344 %

Gear engaged: Reverse gear

Fuel mass torque: 1626.797 %

Tændings vinkel: 63.8 °

Correction factor for air mass flow: 0.282

Gasspjældpositionsføler 1: 219.6 %

Gasspjældpositionsføler 2: 112.9 %

Throttle motor PWM control signal: 7.1 %

Ambience valve switch: 59.6 %

Throttle position sensor voltage copy 1: 16.941 V

Lowest closed throttle voltage: 2.656 V

Longitudinal acceleration sensor: 29.5 m/s²

Absolute intake manifold pressure: 18.1 kPa

Clutch pedal: 87

Intake air temperature sensor (ADC): 54.0 °C

Vehicle speed output: 271.1563 km/h

Battery voltage (ADC): 170.664 V

Intake valve opens related to LWOT angle: -238.9

Intake camshaft position target: -238.9 °

VVT exhaust target angle (bank 1): -- °

Oil temperature: -164.7 °C

Lambda control: 0.141

Multiplicative mixture adaptation (part load): 0.149

Throttle position sensor 1 (ADC): 42.666 V

Throttle position sensor 2 (ADC): 42.334

Additive mixture correction bank 1: 1445.6

Accelerator pedal position 1 fully close (ADC): 67.764 V

Speeder pedal position N2: 170.664 V

Doubled PWG potentiometer 2: 150.4027 V

O2 sensor 2 heater resistance, filtered: 19018.0 Ohm

Exhaust gas temperature sensor 1, bank 1: 546.0 °C

Gear transmission ratio: 5.1

Kortsigtet brændstofafstemning række 1: 199.220

Langsigtet brændstofafstemning, række 1: 199.200 %

Indsprøjtnings tid B1: 59.2 ms

Target idle speed: 850 Omdr.

Ignition timing cylinder 1: 63.8 °

Ignition timing cylinder 2: 63.8 °

Ignition timing cylinder 3: 63.8 °

Ignition timing cylinder 4: 63.8 °

Knock signal cylinder 1: 0.353 V

Knock signal cylinder 2: 0.373 V

Knock signal cylinder 3: 0.353 V

Knock signal cylinder 4: 0.353 V

Lambda sonde /O2 sensor Sted / location: 84

OBD requirements for which this vehicle is designed: 137

Distance since check engine telltale on: 9509 km

Coolant temperature at engine start: 15.8 °C

Canister purge flow: 1.907 kg/h

Target ignition angle: 63.8 °

Total number of misfire: 4626

Misfire cylinder 1: 4626

Misfire cylinder 2: 4883

Misfire cylinder 3: 5140

Misfire cylinder 4: 5397

Misfire range, minimum rpm: 2160.0 Omdr.

Misfire range, maximum rpm: 3400.0 Omdr.

Misfire range, minimum load: 19.9 %

Misfire range, maximum load: 33.2 %

Idle speed control target torque correction: -- %

Idle torque adaptation: -93.3 %

O2 sensor 1, bank 1 (ADC): 106.667 V

O2 sensor 2, bank 1 (ADC): 46.431 V

Indsugningsmanifoldtryk: 170.664 V

Indsugningsmanifoldtryk: 725.781 hPa

Canister purge duty cycle: 14.5 %

Fuel pump relay: Ugyldig

Cooling fan low speed: Ugyldig

Cooling fan high speed: Ugyldig

Target throttle position: 53.6408 %

Intake camshaft duty cycle: 53.3 %

Exhaust camshaft duty cycle: 21.2 %

Ignition status: Tænd

ECM: Ja

Stelnummer programmeret: Ja

PIN code is programmed: Ja

Key programmed: Ja

ECM i startsærres fejlaktiverigstilstand: Ja

Sikkerhedskode for startspærrefunktion: Ja

Wait loop status: Ja

Evaporative emission (EVAP) system, canister purge valve

Brændstofpumperelæ

Electronic throttle control (ETC)

Intake camshaft position actuator, bank 1

Exhaust camshaft position actuator, bank 1

Check motor fejllampe

SVS telltale malfunction

Idle rpm control