Bil, HYUNDAI, General, SONATA (NF), 2007, G 2.4 DOHC, G 2.4 DOHC - Unleaded EOBD (ENGINE)

Calibration ID: --

Clear DTC

A/C-kontakt: Sluk

Variant coding: M/T

A/C status: Sluk

Check motor fejllampe: Sluk

AC compressor: Sluk

Ignition switch: Sluk

Supply power fail: Normal

Brændstofpumpe: Sluk

Throttle closed position: Sluk

Main relay: Sluk

Throttle full open: Sluk

Camshaft and crankshaft synchronization: Sluk

Fuel cut-off: Sluk

Cranking signal: Sluk

Fuel system status: --

Knocking detection: --

O2 sensor 2, bank 1 operation: --

O2 sensor 1, bank 1 operation: --

Drive status: --

Canister purge state: --

Canister purge phase: --

Idle rpm control: --

Luft masse måler: 319.81 V

Luft masse måler: 6553.5 kg/h

Belastning Motor: 1535.9 %

Throttle position PWM servo signal: 100.0 %

Batteri spænding: 17.37 V

Motor kølevæske temperatur føler: 143.2 °C

Engine coolant temperature sensor (model): -- °C

Intake air temperature sensor: -- °C

Tank luft ventil: -- %

Injection time cylinder 1: -- ms

Injection time cylinder 2: -- ms

Injection time cylinder 3: -- ms

Injection time cylinder 4: -- ms

Torque request from TCU: 100.0 %

O2 sensor 1, bank 1 heating time: 2550 ms

O2 sensor 2, bank 1 heating time: 2550 ms

Lambda sonde / O2 sensor 1, bank 1: 1.330 V

Lambda sonde / O2 sensor 2, bank 1: 1.330 V

Target idle speed: 690 Omdr.

Idle speed actuator: 0.4 %

idle speed actuator offset: 0.0 %

Motor Hastighed: 2180.5 Omdr.

Tændings vinkel: -- °

Køretøjs hastighed : -- km/h

Kortsigtet brændstofafstemning række 1: -0.0 %

Long term fuel trim (idle): -0.0 %

Long term fuel trim (part load): -0.0 %

Knock adaption cylinder 1: 0.0 °

Knock adaption cylinder 2: 0.0 °

Knock adaption cylinder 3: 0.0 °

Knock adaption cylinder 4: 0.0 °

Throttle position angle average: 480.0 °

Gasspjældpositionsføler 1: 480.0 °

Gasspjældpositionsføler 2: 480.0 °

Target throttle position: 480.0 °

Gasspjældpositionsføler 1: 320007.4 mV

Gasspjældpositionsføler 2: 320007.4 mV

Accelerator pedal position sensor: 100.0 %

Speeder pedal positions føler N1: 320007.4 mV

Speeder pedal position N2: 320007.4 mV

CVVT adaption PWM: 52.2 %

CVVT duty control status: -

Inlet CAM position: 155.6 °

Target camshaft position: 155.6 °

CVVT valve duty: 100.0 %

Check motor fejllampe

Brændstofpumperelæ

A/C compressor relay

Main relay

Evaporative emission (EVAP) system, canister purge valve

Oil control valve (CVVT)

Cooling fan high speed relay

Cooling fan low speed relay

Electronic throttle control (ETC)

Immobilizer telltale

Canister close valve

Canister Close Valve-Clocked

indsprøjtnings dyser

Resetting adaptive values

Auto detected configuration reset

Cylinder Power Balance (Option)

CVVT Test

Idle RPM Control Test(ISC Type Only)

MAF circuit test