Bil, GEELY, Atlas, JLD-4G24 - Bosch ME17.8.8.1 (2.4L) (ECM)
JLD-4G24 - Bosch ME17.8.8.1 (2.4L) (ECM) - 0
Identifikation
Vehicle name: 12345678
Drawing number: 3589@ABC
Supplier identification: system supplier identifier: 456789@BEF
Stel nr.:
Supplier ECU hardware number: 121416181@1B1D1F1
Hardware version for suppliers: system supplier ECU hardware version number:
Software version for suppliers: system supplier ECU software version number: 8mg10p3p41245678
Typegodkendelse nr.: 33445566
Motortype: DDEEFF
Repair shop code or tester serial number: 234567
Programming date: 31323334
ECU installation date: 55444241
Fejlkoder
P101100: Ukendt fejlkode
P111213: Ukendt fejlkode
Controls
Clear DTC
Levende Data
Motor Hastighed: 0.0 Omdr.
Tid siden motor start: 462.6 sek
Køretøjets hastighed sensor: 512.0 km/h
Ambient pressure: 0.0 hPa
Batteri spænding: 0.00 V
Throttle angle with respect to lower mechanical stop: 125.5 %
Intake air temperature sensor: -48.0 °C
Omgivende lufttemperatur: -48.0 °C
Accelerator pedal position sensor: 0.0 %
Fuel flow: 0.0 L/s
Fuel flow: 0.0 hPa
Luft-/brændstofforhold: 0.0
Maximum engine torque: 680.0 N·m
Luft masse måler: 0.0 kg/h
O2 sensor downstream catalyst: 0.43 V
Relative engine load: 0.0 %
ETS-path as environmental condition for diagnosis of function monitoring: 0
Torque path in function and function monitoring as environmental condition of diagnostic: 68
Actual torque at response of torque comparison in the function monitoring: 0.0 %
Model-based substitute value for engine temperature signal in case of error: -48.0 °C
Target throttle angle with respect to lower mechanical stop: 53.3 %
Exhaust temperature downstream catalyst: 305.0 °C
Motor kølevæske temperatur føler: -48.0 °C
Engine coolant temperature sensor (model): 54.0 °C
Calculated actual torque in function monitoring: 7.0 %
Aktuelt gear: 136
Tændings vinkel: 0.0 Grad kw
Throttle blade position dependent on potentiometer 1: 0.4 %
Throttle blade position dependent on potentiometer 2: 1.7 %
DLR for DV-E: sum of the PID-components (throttle actuator control PWM): 0.0 %
Diagnosis: 8 bit copy of wdknlp_w as ambient value: 0.0 %
Sensor voltage from throttle potentiometer 2: 0.00 V
Sensor voltage from throttle potentiometer 1: 0.00 V
Automobile acceleration in the longitudinal direction: 18.4 m/s²
Sensor voltage from throttle potentiometer 2 at the mechanical BDC: 2.66 V
Ambient air pressure sensor voltage: 0.00 V
Adapted ambient pressure: 0.0 hPa
Absolute intake manifold pressure: 1194.6 hPa
Number of clutch operations detected: 0
Intake air temperature sensor: 54.0 °C
Vehicle speed output: 0.0 km/h
VVT phase angle: 0.0 Grad kw
Desired camshaft angle inlet valve opened: 0.0 Grad kw
Variation of angle of camshaft to crankshaft: 546.1 kW
Oil temperature: -273.1 °C
Target air/fuel ratio: 0.0
Sensor voltage from throttle potentiometer 1: 0.00 V
Sensor voltage from throttle potentiometer 2: 0.00 V
VVT intake control: 0.0 %
Additive correction of the mixture adaptation: 0.0
PWG potentiometer 1: 0.00 V
PWG potentiometer 2: 0.00 V
PWG potentiometer 2: 0.00 V
O2 sensor 2, bank 1 internal resistance: 0.0 Ohm
Target idle speed: 0 Omdr.
Ignition-timing retardation for dynamics cylinder 1: 0.0 Grad kw
Ignition-timing retardation for dynamics cylinder 2: 0.0 Grad kw
Ignition-timing retardation for dynamics cylinder 3: 0.0 Grad kw
Ignition-timing retardation for dynamics cylinder 4: 0.0 Grad kw
Reference level knock control, cylinder 1: 0.00 V
Reference level knock control, cylinder 2: 0.00 V
Reference level knock control, cylinder 3: 0.00 V
Reference level knock control, cylinder 4: 0.00 V
Coolant temperature at engine start: -48.0 °C
Canister purge flow: 0.0 kg/h
Target ignition angle: 0.0 Grad kw
Total counter of emission relevant misfiring of all cylinders: 0
Misfire cylinder 1: 0
Misfire cylinder 2: 0
Misfire cylinder 3: 0
Misfire cylinder 4: 0
Cycle time forced lambda modulation: 0
Torque correction for idle speed control: 80.8 %
Misfire range, minimum load: 53.1 %
Misfire range, maximum load: 33.2 %
Maximum engine torque: 0.0 %
Real engine torque: 0.0 %
Engine Temperature: -48.0 °C
Kilometer tæller: 4294967295 km
Coverage engine on time: 4294967295 sek
Distance since check engine telltale on: 25942 km
Lambda sonde / O2 sensor 1, bank 1: 22.75 V
Lambda sonde / O2 sensor 2, bank 1: 25.59 V
Actual intake air manifold pressure: 22.84 V
Engine-drag torque: 16.0 %
Engine speed maximum area of misfire: 5440.0 Omdr.
Engine speed minimum area of misfire: 2760.5 Omdr.
Immobilizer state kessy: learning status: 0
Fuel pump relay: Åben
Cooling fan low speed: Åben
Cooling fan high speed: Åben
Kommando til relæ til A/C-kompressorkobling: Åben
Gasspjæld position vinkel: 53.3 %
Udgangs test
Controls
Brændstofpumperelæ
Cooling fan low speed relay
Cooling fan high speed relay
Canister purge valve test
Throttle angle with respect to lower mechanical stop
Inlet camshaft signal
Muligheder
Controls
Rediger stel nr.
Vehicle Name Writing
Edit ECU installation date
Software reset
Hardware reset