Car, SSANGYONG, Korando C (C205), G20DF (ECM)
G20DF (ECM) - 0
Identification
Boot software number: KR774652_S01
Supplier ECU software number: KR774652_C03
Software ID: Y41B1010
Software version: G20DFEU5+Y41
Hardware number: SIM2K241C201
Lot number: TED
Calibration ID: 4KR774652VC03DEFGHIQRSUTUwwwuvtsrqihg
Calibration version:
Part number: 123456789A
VIN no:
DTC
P0301: Misfire detected, cylinder 1
Controls
Clear DTC
Data stream
Injection time cylinder 1: 12.3 ms
Injection time cylinder 2: 12.3 ms
Injection time cylinder 3: 12.3 ms
Injection time cylinder 4: 12.3 ms
Cruise control release request: On
Cruise control main telltale: Off
Cruise control set telltale: Off
Cruise control active: Off
Ignition angle cylinder 1: 0.0 °
Ignition angle cylinder 2: 0.0 °
Ignition angle cylinder 3: 0.0 °
Ignition angle cylinder 4: 0.0 °
Cruise control switch signal: 3.74 V
Cruise control switch: Resume
Status switch off condition reversible: Main switch OFF
Status switch off condition irreversible : Not relevant
Check engine telltale: On
Variant coding: at
A/C on condition: Off
A/C switch: Off
A/C compressor: Off
Condition Fuel Cut Off: Off
Throttle position at idle position: Off
Throttle wide open position: Off
Ignition on: Off
Fuel pump: Off
Main relay: On
Clutch switch (M/T only): Off
Brake switch: Off
Engine running detected: Off
Battery voltage: 12.46 V
Intake manifold pressure: 989.45 mbar
Throttle position sensor: 7.1 %
Accelerator pedal position sensor signal: 0.0 %
Engine coolant temperature sensor: 42.0 °C
Coolant temperature at engine start: 42.0 °C
Intake air temperature: 31.5 °C
Engine oil temperature: 45.8 °C
A/T oil temperature: 39.0 °C
Ambient temperature: 24.8 °C
Gear engaged: P/N
A/C pressure: 6.7 bar
Vehicle speed: 0 km/h
O2 sensor 1, bank 1: 0.431 V
O2 sensor 2, bank 1: 0.426 V
O2 sensor correction: -0.4 %
O2 sensor 1, bank 1 correction (idle): 5.1 %
O2 sensor 1, bank 1 correction (part load): -0.4 %
Target air/fuel ratio: 1.004
Evaporative emission (EVAP) system, canister purge valve: 0.0 %
Engine speed: 0 rpm
Target idle speed: 1000 rpm
Engine load: 0.0 %
Engine running time: 0 min
Fuel consumption: 0 km/l
Intake camshaft bank 1 actual position: 126.0 °
Actuators test
Controls
Check engine telltale
Fuel pump relay
A/C compressor relay
Immobilizer telltale
Cooling fan high speed relay
Cooling fan low speed relay
Main relay
Evaporative emission (EVAP) system, canister purge valve
Oil control valve (CVVT)
ETC Motor
O2 sensor 1, bank 1 heater
O2 sensor 2, bank 1 heater
Cruise control main telltale
Cruise control set telltale
Injectors
Utility
Controls
Edit VIN
ECU initialization
Configuration
Controls
Edit configuration
Edit parameter configuration