Bil, SSANGYONG, Korando C (C205), G20DF (ECM)
G20DF (ECM) - 0
Identifikation
Boot software number: KR774652_S01
Supplier ECU software number: KR774652_C03
Software ID: Y41B1010
Softwareversion: G20DFEU5+Y41
Hardware number: SIM2K241C201
Lot number: TED
Calibration ID: 4KR774652VC03DEFGHIQRSUTUwwwuvtsrqihg
Calibration version:
Dele nummer: 123456789A
Stel nr.:
Fejlkoder
P0301: Cylinder 1 fejltænding påvist
Controls
Clear DTC
Levende Data
Injection time cylinder 1: 12.3 ms
Injection time cylinder 2: 12.3 ms
Injection time cylinder 3: 12.3 ms
Injection time cylinder 4: 12.3 ms
Cruise control release request: Tænd
Cruise control main telltale: Sluk
Cruise control set telltale: Sluk
Fartpilot aktiv: Sluk
Ignition angle cylinder 1: 0.0 °
Ignition angle cylinder 2: 0.0 °
Ignition angle cylinder 3: 0.0 °
Ignition angle cylinder 4: 0.0 °
Cruise control switch signal: 3.74 V
Fartpilotkontakt: Genoptag
Status switch off condition reversible: Main switch OFF
Status switch off condition irreversible : Not relevant
Check motor fejllampe: Tænd
Variant coding: at
A/C on condition: Sluk
A/C-kontakt: Sluk
AC compressor: Sluk
Condition Fuel Cut Off: Sluk
Throttle position at idle position: Sluk
Throttle wide open position: Sluk
Tænding til: Sluk
Brændstofpumpe: Sluk
Main relay: Tænd
Clutch switch (M/T only): Sluk
Brake switch: Sluk
Engine running detected: Sluk
Batteri spænding: 12.46 V
Indsugningsmanifoldtryk: 989.45 mbar
Gasspjælds positions føler: 7.1 %
Accelerator pedal position sensor signal: 0.0 %
Motor kølevæske temperatur føler: 42.0 °C
Coolant temperature at engine start: 42.0 °C
Indsugningslufttemperatur: 31.5 °C
Motorolietemperatur: 45.8 °C
A/T oil temperature: 39.0 °C
Ambient temperature: 24.8 °C
Gear engaged: P/N
A/C pressure: 6.7 bar
Køretøjs hastighed : 0 km/h
Lambda sonde / O2 sensor 1, bank 1: 0.431 V
Lambda sonde / O2 sensor 2, bank 1: 0.426 V
O2 sensor correction: -0.4 %
O2 sensor 1, bank 1 correction (idle): 5.1 %
O2 sensor 1, bank 1 correction (part load): -0.4 %
Target air/fuel ratio: 1.004
Tank luft ventil: 0.0 %
Motor Hastighed: 0 Omdr.
Target idle speed: 1000 Omdr.
Belastning Motor: 0.0 %
Engine running time: 0 min
Fuel consumption: 0 km/l
Intake camshaft bank 1 actual position: 126.0 °
Udgangs test
Controls
Check motor fejllampe
Brændstofpumperelæ
A/C compressor relay
Immobilizer telltale
Cooling fan high speed relay
Cooling fan low speed relay
Main relay
Evaporative emission (EVAP) system, canister purge valve
Oil control valve (CVVT)
ETC Motor
O2 sensor 1, bank 1 heater
O2 sensor / Lambda sonde 2, bank 1 Varme element
Cruise control main telltale
Cruise control set telltale
indsprøjtnings dyser
Muligheder
Controls
Rediger stel nr.
ECU initialization
Konfiguration
Controls
Redigere konfiguration
Edit parameter configuration