Car, PEUGEOT, PARTNER, CAN, 9HS - EDC16C3

9HS - EDC16C3 - 0

Identification

PSA reference: 96 53 95 89 80

ECU manufacturer: Bosch

Additional number: 96 64 35 69 80

Software version: 04 01

Software reference: 65 67 40

DTC

P2144: Exhaust gas recirculation (EGR) valve - circuit short to ground

Controls

Clear DTC

Data stream

Additional heater: Cut-off

Inlet air temperature at manifold: 15.8 °C

Learn status: Incorrect; First EGR vlve programming correct; Last EGR butterfly programming correct; First EGR butterfly programming correct; Incorrect; Incorrect; ;

Barometric pressure sensor: 0.976 bar

Turbocharging pressure measured: 0.988 bar

Brake pedal switch 1: Released

Brake pedal switch 2: Released

A/C authorisation: No

Vehicle speed sensor: 0 km/h

Clutch pedal: Released

Gear engaged: Neutral

Fuel temperature sensor: 44.7 °C

A/C pressure sensor: 1.0 bar

Configuration: Correct

Engine coolant temperature sensor: 62.6 °C

Cooling fan relay: Inactive

Cooling fan speed: 0.0 %

Cooling fan reference speed: 0.0 %

Battery voltage: 12.45 V

EGR valve position repeat: 0.0 %

Camshaft and crankshaft synchronization: No

Fuel flow regulator: 13.7 %

Diesel output delivered by the pump reference value: 7741.2 mm³/s

Engine status: Ignition on

EGR valve open cycle ratio: 0.0 %

Pre-post heating relay: Inactive

A/C cut-off request: Cut-off

Engine speed: 803.1 rpm

Fuel pressure measured: 345.1 bar

Accelerator pedal position sensor: 0.0 %

Injected fuel quantity: 4.7 mg/impulse

Mass air flow sensor: 235.3 mg/impulse

Pre-injection advance 1: 19.1 °

Fuel injection advance (main): 0.7 °

Injector control error status: No fault

Turbocharging pressure reference value: 1.012 bar

Reference fuel pressure: 337.3 bar

Turbo pressure duty cycle: 64.3 %

Bypass throttle solenoid valve open cycle ratio: 0.0 %

EGR throttle electrovalve open cycle ratio: 70.2 %

Intake air temperature sensor: 32 °C

Air flow reference for EGR: 231.5 mg/impulse

Bypass flap position repeat (if present): 0.0 %

DPF information

Additive adding system fault:

Air flow volume: 686.3 kg/h

Catalytic converter downstream temperature: 349.4 °C

Exhaust gas differential pressure: 117.6 mbar

Intake air temperature sensor: 32 °C

Diesel Particulate filter (DPF) load state: 0.0 %

Average distance between the last 5 regenerations: 0.0 km

Diesel Particulate filter (DPF) distance since last regeneration: 0.0 km

Weight of additive in the PEF: 0.0 g

Volume of additive remaining in the reservoir: 3000.0 ml

Immobilizer

Locking of the ECU: Unlocked

Immobilizer status: Matched ECU

Problem detected when transmitting the unlock code: No problem

Actuators test

Controls

Cooling fan high speed

Cooling fan low speed

Additional heating relay

EGR valve

EGR throttle

Turbocharger control solenoid valve

Fuel flow regulator

Pre-post heating relay control

Additive pump

Utility

Controls

Diesel particulate filter replacement

Diesel particulate filter static regeneration

Diesel particulate filter dynamic regeneration

EGR valve change

Programming of the additive system if replacing parts (additive reservoir, pump or pipes)

Injectors replacement