Car, OPEL, Vectra C, 2008, Z30DT - DECD2

VIN no: W0L0ZCF6961090222

System identification: MOTOR0100

Existing ECU type approval no: G04005

System: Z22SE

Identifier: 10 01

Software version number: 34120302

Part number: 12581933

Hardware number: 12563556

Alpha code: CA

P0304 [0]: Misfire detected, cylinder 4

P0251 [1]: Fuel rail pressure control valve 1 or 2 - circuit high voltage

P0235 [11]: Turbocharger boost pressure control circuit positive deviation

P0409 [7]: Exhaust gas recirculation (EGR) valve position sensor 1/A/single - circuit high voltage

Clear DTC

Cooling fan relay 1: On

Cooling fan relay 2: On

Cooling fan relay 3: On

A/C information switch: Off

A/C relay: On

A/C compressor stroke release: Slow shutdown

A/C cut-off mode: Max torque

Oil level: Low

Engine oil level status: Warning

Engine oil life remaining: 61 %

Engine oil change warning: Active

Engine oil pressure: Low pressure

Ignition status: On

Power supply relay: Off

Glow time telltale: On

Glow time relay: On

Accelerator pedal position at idle position: No

Idle speed modified: No

Brake pedal switch 1: On

Clutch switch: On

Vehicle speed in cruise control range: Active

Cruise control tip switch: Invalid

Brake pedal switch 2: On

Cruise control: Active

Check engine telltale: On

Service vehicle soon telltale: Off

Battery voltage: 38.08 V

Engine speed: 0 rpm

Target idle speed: 1025 rpm

Acceleration sensor: 5 m/s²

Vehicle speed sensor: 0 km/h

Engine coolant temperature sensor: 0.14 V

Engine coolant temperature sensor: 210 °C

Charge air temperature sensor: 1.00 V

Charge air temperature sensor: 215 °C

Intake air temperature sensor: 149 °C

A/C pressure sensor: 5.00 V

A/C pressure sensor: 28 kPa

Mass air flow sensor: 0.02 V

Mass air flow sensor: 489 mg/strk

Boost pressure sensor: 0.69 V

Boost pressure sensor: 19 kPa

Boost pressure command: 68 kPa

Accelerator pedal position sensor 1: 4.59 V

Accelerator pedal position sensor 2: 0.00 V

Accelerator pedal position 1 fully close learn: 0.00 V

Calculated accelerator pedal position: 32 %

EGR valve: 9 %

EGR valve: 100 %

EGR valve: 0.69 V

Fuel level sensor: 0.67 V

Diesel Particulate filter (DPF) differential pressure: 4.90 V

Diesel Particulate filter (DPF) differential pressure: 23 kPa

Exhaust gas temperature sensor 1, bank 1: 5.00 V

Exhaust gas temperature sensor 1, bank 1: 905 °C

Exhaust gas temperature sensor 2, bank 1: 5.00 V

Exhaust gas temperature sensor 2, bank 1: -30 °C

Diesel Particulate filter (DPF) saturation: 1 %

Boost pressure solenoid valve - duty cycle: 3 %

Barometric pressure sensor: 5.00 V

Barometric pressure sensor: 1 kPa

Actual injection quantity: 1 mm³/stk

Actual injection start: 11 °

Fuel rail pressure: 5.00 V

Fuel rail pressure: 70.07 MPa

Target fuel rail pressure: 68.19 MPa

Engine oil temperature sensor: 0.02 V

Engine oil temperature sensor: -16 °C

Fuel temperature sensor: 5.00 V

Fuel temperature sensor: -5 °C

Throttle position sensor: 0.02 V

Throttle position sensor: 9 %

Throttle position PWM servo signal: 100 %

Swirl: Active

Swirl flap sensor, bank 1: Active

Swirl flap sensor, bank 2: Not active

Injection quantity: Not active

Injection quantity: Not active

Delivery mode: Active

Immobilizer function programmed: No

Immobilizer function programmed: No

Free start mode: Not active

Security wait time: Not active

Security wait time: Not active

Engine oil life remaining: 61 %

Engine oil change warning: Active

Engine oil pressure: Low pressure

EGR valve

Boost pressure valve

Glow time relay

Throttle valve actuator

Check engine telltale

Glow time telltale

Fuel pressure solenoid valve 1

Fuel pressure solenoid valve 2

Fuel system leakage test

Swirl flap - control solenoid

Injectors

Reset oil life

Differential pressure sensor replacement

Diesel particulate filter replacement

Adjust idle speed

Edit tire circumference