Bil, HYUNDAI, General, GRAND SANTAFE (NC), 2016, D 2.2 TCI-R, D 2.2 TCI-R - Engine Control (ENGINE)

D 2.2 TCI-R - Engine Control (ENGINE) - 0

Identifikation

RB plan code :: FF FF

CCS name :: FF FF

ECU serial number :: FF FF

Date :: FF FF FF FF FF

SubSystem ECU Software Number ::

Kalibreringsnummer:

CVN data :: FF FF FF FF

Stel nr.:

Dele nummer:

Fejlkoder

Controls

Clear DTC

Levende Data

Ladetrykføler: -- hPa

Accelerator pedal position sensor: 100.0 %

Fuel rail pressure control valve: 100.0 %

Mass air flow per cylinder: 1500.0 mg/hub

Barometrisk tryk føler: 3500.0 hPa

Brake pedal switch 1: Tænd

Blower switch: Tænd

A/C compressor relay: Tænd

Ignition switch: Tænd

Clutch switch (M/T only): Tænd

A/C-kontakt: Tænd

Brake pedal switch 2: Tænd

Gearbox neutral position status signal: Tænd

Accelerator Pedal Position Sensor-1 Voltage: 5.000 V

Accelerator Pedal Position Sensor-2 Voltage: 5.000 V

Check motor fejllampe: Tænd

GRU(Glow Relay Unit) control unit: 100.0 %

Fuel quantity: 100.0 mm³

Batteri spænding: 20.84 V

Køretøjs hastighed : 299.9 km/h

Cooling fan low speed: 100.0 %

Cooling fan high speed: Tænd

Fuel pump relay: Tænd

Boost pressure actuator: 100.0 %

Brændstoftemperaturføler: 150.000 °C

Camshaft and crankshaft synchronization:

Motor status: Kører

PTC heater relay: --

Immobilizer telltale: --

Fuel pressure set point: -- hPa

Output of fuel metering unit (MPROP): -- %

A/C pressure sensor: -- psi

A/C pressure sensor: -- V

Raw voltage of exhaust temperature sensor 1 (Upstream of the Oxidation Catalyst) (CPF option): -- V

Raw voltage of temperature at upstream of the DPF: -- V

Diesel Particulate filter (DPF) differential pressure sensor raw value: -- V

O2 sensor 1, bank 1 subtraction: -- V

Equivalence ratio (lambda) sensor 1, bank 1: --

O2 sensor 1, bank 1 temperature: -- °C

O2 sensor 1, bank 1 heater: -- %

O2 sensor 1, bank 1 state of adaptation: --

Oil level raw value: -- mm

Oil temperature sensor: -- °C

Oil level average value: -- mm

Oil level: --

Active operation mode: 4294967295

Diesel Particulate filter (DPF) differential pressure: 32767.000 hPa

Exhaust temperature sensor 1 (CPF option): 1300.000 °C

Exhaust temperature sensor 2 (CPF option): 1300.000 °C

Diesel Particulate filter (DPF) charge state: 255

Total driven distance at last successful regeneration: 4294967.295 km

Driven distance since last successful regeneration: 4294967.295 km

Coverage driven length: 4294967.295 km

Calculated load value: 100.0 %

Raw voltage of boost pressure sensor: 5.000 V

Control deviation of the exhaust-gas recirculation control: 3276.0 mg/hub

Vehicle acceleration: 64.0 m/s²

Status of plausibility APP/Brk: --

Driver torque lead value of propulsion: -- N·m

Gear information: --

TCU fault status: --

OBD status of TCU: --

Torque reduction request: -- %

Current value of frictional torque: -- %

Engine displacement: -- L

Engine characteristics status: --

Actual engine torque - Crankshaft torque: -- N·m

Inner torque without transmission interventions: -- N·m

State of immo presence: --

Gearkassetype: --

Nominal value of inner torque: -- N·m

Fartpilot: --

Status of TCS request: --

Status of MSR request: --

Status of ABS request: --

Torque reduction request from TCS: -- %

Torque reduction request from MSR: -- %

Status of TCS request acknowledgement: --

TSC decreasing torque intervention: -- N·m

Error indication of engine speed sensine: --

Indication of fuel cut-off state: --

Air mass sensor error indication: --

Current value of inner torque: -- %

Desired value of inner torque: -- %

Ratio of throttle valve: -- %

Bypassventil til EGR-køler: -- %

Voltage raw value of fuel temperature: -- V

Glow control lamp output: --

Raw value intake air temperature in volt: -- V

Desired injection quantity (MI1): -- mm³

Target injection quantity (Pilot 1): -- mm³

Target injection quantity (Pilot 2): -- mm³

Target injection quantity (Pilot 3): -- mm³

Target injection quantity (post 1): -- mm³

Target injection quantity (post 2): -- mm³

Injection quantity: -- mm³

Motorolietemperatur: -- °C

Raw value of rail pressure: -- V

Engine ON time: -- sek

Distance since check engine telltale on: --

Final stop enable signal: Ja

Final stop request signal: Tænd

Final start enable signal: Ja

Final start request signal: Tænd

Motor kølevæske temperatur føler: 16947 °C

Barometrisk tryk føler: 1275 hPa

Motor Hastighed: 8883.5 Omdr.

Stop enable by brake booster (less than -350hpa): --

Stop enable by safety condition (seat/Door/hood): --

Stop enable by battery (SOC/SOF/SOH): --

Stop enable by air conditioner: --

Stop enable from EMS: --

Stop enable from OBD: --

Stop enable from SPAS: --

Braking system is not operating: --

Stop enable by TCU: --

Stop enable by HAC: --

Accel pedal is pressed: --

Køretøjs hastighed : -- km/h

Brake pedal is surely pressed: --

Tryk i hovedbremsecylinder: -- bar

Gear level is D: --

Gear level is N: --

Stop request signal at gear D: --

Stop request signal at gear N: --

No ISG related diagnostic error: --

Starter ON signal: Ja

ISG system built-in(ISG): Ja

Starter request by key: Ja

ISG Status(ISG): Tænd

Clutch is pushed more than 40%: Ja

AMS stop reason - blower max switch (AMS): Ja

Idle stop request by drivers demand(ISG): Ja

Gear is on neutral position: Ja

Driver`s Seat Belt: Unbelted

Førerdør: Åben

Kontakt for motorhjelm åben: Åben

Battery current (AMS): 1.8 A

Battery voltage (AMS): 8.550 V

Battery temperature (AMS): 19.0 °C

State of battery charge (AMS): 255 %

State of health of battery (AMS): 255 %

State of function of battery (AMS): 12.750 V

Idle stop or engine stall: Tænd

Brake boost vacuum pressure: -0.039 hPa

Brake boost vacuum pressure Voltage(ISG): 314.568 V

Nominal capacity (AMS): 255 Ah

Battery sensor in invalid condition (AMS): Ja

Flag status of battery charge (AMS): Ja

Response error flag from battery sensor (AMS): Ja

Flag status of battery health (Aging) (AMS): Ja

Flag status of battery function to crank the engine (AMS): Ja

Flag status of quiescent current (AMS): Ja

AMS stop reason - head lamp (AMS): Ja

AMS stop reason - wiper (AMS): Ja

Equivalence ratio (lambda) sensor 2, bank 1: 64.000

Batteristrøm: -- A

Batteri spænding: -- V

Batteritemperatur: -- °C

Total sulphur mass: 9999.986 mg

Udgangs test

Controls

Boost Pressure Actuator 5%

Boost Pressure Actuator 95%

Muligheder

Controls

Rediger stel nr.

Injectors replacement

ECU Change (CPF option)

Lambda sensor change

Rail pressure sensor change

Air Flow Sensor Change

Differential pressure sensor replacement (CPF option)

Swirl control valve change

Throttle adaptation reset

EGR valve change

APS module change

Converter ASSY(LNT+DPF)

Idle speed comparison

Injection quantity comparison

Fuel line air removal

Diesel Particulate filter (DPF) regeneration

ECU Tuning Data Confirm

Generator test (Option)

Lambda sensor (LSU) cleaning