PKW, HYUNDAI, General, GRAND SANTAFE (NC), 2016, D 2.2 TCI-R, D 2.2 TCI-R - Engine Control (ENGINE)

D 2.2 TCI-R - Engine Control (ENGINE) - 0

Identifikation

RB plan code :: FF FF

CCS name :: FF FF

ECU serial number :: FF FF

Date :: FF FF FF FF FF

SubSystem ECU Software Number ::

Kalibrierungsnummer:

CVN data :: FF FF FF FF

FIN:

Ersatzteilnummer:

Fehlercode

Controls

Fehlercode löschen

Ist-Werte

Ladedrucksensor: -- hPa

Geber für Gaspedalstellung: 100.0 %

Druckregelventil: 100.0 %

Luftmasse pro Zylinder: 1500.0 mg/hub

Luftdrucksensor: 3500.0 hPa

Bremspedal-Schalter 1: EIN

Gebläse-Schalter: EIN

Relais für Klimakompressor: EIN

Zündschalter: EIN

Kupplungsschalter (nur Handschaltgetriebe): EIN

Schalter für Klimaanlage: EIN

Bremspedal-Schalter 2: EIN

Statussignal für die Neutralstellung des Getriebes: EIN

Accelerator Pedal Position Sensor-1 Voltage: 5.000 V

Accelerator Pedal Position Sensor-2 Voltage: 5.000 V

Motorwarnlampe: EIN

GRU(Glow Relay Unit) control unit: 100.0 %

Kraftstoffmenge: 100.0 mm³

Batteriespannung: 20.84 V

Fahrgeschwindigkeit: 299.9 km/h

Kühlgebläse niedrige Geschwindigkeit : 100.0 %

Cooling fan high speed: EIN

Kraftstoffpumpenrelais: EIN

Boost pressure actuator: 100.0 %

Geber für Kraftstofftemperatur: 150.000 °C

Camshaft and cranckshaft synchronization:

Motorzustand: Läuft

PTC heater relay: --

Anzeige Wegfahrsperre : --

Fuel pressure set point: -- hPa

Output of fuel metering unit (MPROP): -- %

A/C Drucksensor: -- psi

A/C Drucksensor: -- V

Raw voltage of exhaust temperature sensor 1 (Upstream of the Oxidation Catalyst) (CPF option): -- V

Raw voltage of temperature at upstream of the DPF: -- V

Diesel Particulate filter (DPF) differential pressure sensor raw value: -- V

O2 sensor 1, bank 1 subtraction: -- V

Equivalence ratio (lambda) sensor 1, bank 1: --

Lambdasonde 1, Bank 1 Temperatur: -- °C

Sonde 1, Bank 1 Heizstromkreis: -- %

O2 sensor 1, bank 1 state of adaptation: --

Oil level raw value: -- mm

Sensor Öltemperatur: -- °C

Oil level average value: -- mm

Ölstand: --

Active operation mode: 4294967295

Diesel Particulate filter (DPF) differential pressure: 32767.000 hPa

Exhaust temperature sensor 1 (CPF option): 1300.000 °C

Exhaust temperature sensor 2 (CPF option): 1300.000 °C

Diesel Particulate filter (DPF) charge state: 255

Total driven distance at last successful regeneration: 4294967.295 km

Driven distance since last successful regeneration: 4294967.295 km

Coverage driven length: 4294967.295 km

Berechneter Lastwert: 100.0 %

Raw voltage of boost pressure sensor: 5.000 V

Control deviation of the exhaust-gas recirculation control: 3276.0 mg/hub

Fahrzeugbeschleunigung: 64.0 m/s²

Status of plausibility APP/Brk: --

Driver torque lead value of propulsion: -- N·m

Gear information: --

TCU fault status: --

OBD status of TCU: --

Torque reduction request: -- %

Current value of frictional torque: -- %

Hubraum: -- L

Engine characteristics status: --

Actual engine torque - Crankshaft torque: -- N·m

Inner torque without transmission interventions: -- N·m

State of immo presence: --

Getriebetyp: --

Nominal value of inner torque: -- N·m

Geschwindigkeitsregelanlage: --

Status of TCS request: --

Status of MSR request: --

Status of ABS request: --

Torque reduction request from TCS: -- %

Torque reduction request from MSR: -- %

Status of TCS request acknowledgement: --

TSC decreasing torque intervention: -- N·m

Error indication of engine speed sensine: --

Indication of fuel cut-off state: --

Air mass sensor error indication: --

Current value of inner torque: -- %

Desired value of inner torque: -- %

Ratio of throttle valve: -- %

Ventil AGR-Kühler-Bypass: -- %

Voltage raw value of fuel temperature: -- V

Glow control lamp output: --

Raw value intake air temperature in volt: -- V

Desired injection quantity (MI1): -- mm³

Target injection quantity (Pilot 1): -- mm³

Target injection quantity (Pilot 2): -- mm³

Target injection quantity (Pilot 3): -- mm³

Target injection quantity (post 1): -- mm³

Target injection quantity (post 2): -- mm³

Einspritzmenge: -- mm³

Motoröltemperatur: -- °C

Raw value of rail pressure: -- V

Engine ON time: -- sec

Zurückgelegte Strecke seit Motorleuchte an ist: --

Final stop enable signal: Ja

Final stop request signal: EIN

Final start enable signal: Ja

Final start request signal: EIN

Geber für Kühlmitteltemperatur: 16947 °C

Luftdrucksensor: 1275 hPa

Motordrehzahl: 8883.5 UpM

Stop enable by brake booster (less than -350hpa): --

Stop enable by safety condition (seat/Door/hood): --

Stop enable by battery (SOC/SOF/SOH): --

Stop enable by air conditioner: --

Stop enable from EMS: --

Stop enable from OBD: --

Stop enable from SPAS: --

Braking system is not operating: --

Stop enable by TCU: --

Stop enable by HAC: --

Accel pedal is pressed: --

Fahrgeschwindigkeit: -- km/h

Brake pedal is surely pressed: --

Druck Hauptbremszylinder: -- Bar

Gear level is D: --

Gear level is N: --

Stop request signal at gear D: --

Stop request signal at gear N: --

No ISG related diagnostic error: --

Starter ON signal: Ja

ISG system built-in(ISG): Ja

Starter request by key: Ja

ISG Status(ISG): EIN

Clutch is pushed more than 40%: Ja

AMS stop reason - blower max switch (AMS): Ja

Idle stop request by drivers demand(ISG): Ja

Gear is on neutral position: Ja

Driver`s Seat Belt: Unbelted

Fahrertür: Offen

Motorhaube-Schalter: Offen

Batteriestrom (AMS): 1.8 A

Batteriespannung (AMS): 8.550 V

Batterietemperatur (AMS): 19.0 °C

Zustand der Batterieladung (AMS): 255 %

State of health of battery (AMS): 255 %

State of function of battery (AMS): 12.750 V

Idle stop or engine stall: EIN

Brake boost vacuum pressure: -0.039 hPa

Brake boost vacuum pressure Voltage(ISG): 314.568 V

Nennleistung (AMS): 255 Ah

Battery sensor in invalid condition (AMS): Ja

Flag status of battery charge (AMS): Ja

Response error flag from battery sensor (AMS): Ja

Flag status of battery health (Aging) (AMS): Ja

Flag status of battery function to crank the engine (AMS): Ja

Flag status of quiescent current (AMS): Ja

AMS stop reason - head lamp (AMS): Ja

AMS stop reason - wiper (AMS): Ja

Equivalence ratio (lambda) sensor 2, bank 1: 64.000

Batteriestrom: -- A

Batteriespannung: -- V

Batterietemperatur: -- °C

Total sulphur mass: 9999.986 mg

Stellgliedtest

Controls

Ladedruck Stellantrieb 5%

Boost Pressure Actuator 95%

Dienst­programme

Controls

VIN ändern

Austausch Einspritzventile

ECU Change (CPF option)

Lambda sensor change

Rail pressure sensor change

Air Flow Sensor Change

Differential pressure sensor replacement (CPF option)

Swirl control valve change

Reset Drosselklappe Adaptation

Austausch des AGR-Ventils

APS module change

Converter ASSY(LNT+DPF)

Leerlaufvergleich

Injection quantity comparison

Fuel line air removal

DPF-Regeneration

ECU Tuning Data Confirm

Generator test (Option)

Lambda sensor (LSU) cleaning