Car, LIFAN, 320 SMILY, Suntech engine (ECM)

Part number: 0E002--

Serial number: 65535

Engine type:

P0508: Unknown DTC

P0037: O2 sensor 2, bank 1 heater - circuit low voltage

P0650: Check engine telltale - circuit malfunction

P0261: Injector cylinder 1 - circuit low voltage

P0270: Injector cylinder 4 - circuit low voltage

Clear DTC

Battery voltage: 14.43 V

Other diagnostic voltage modes: Active

Ignition switch: On

Battery disconnect: No

Voltage jump: Off

Information bit for battery disconnection: No

OBD-I diagnostic voltage mode: Active

OBD-II diagnostic voltage mode: Active

Engine coolant temperature sensor: 1.35 V

Engine coolant temperature sensor: 84.0 °C

Intake air temperature sensor: 2.17 V

Intake air temperature sensor: 57.8 °C

Throttle position sensor: 0.49 V

Throttle position sensor: 0.0 °

Throttle position sensor adaptation (close): 11.7 °

MAP sensor: 1.25 V

Mass air flow sensor: 8.0 kg/h

MAP sensor: 30.4 kPa

Positive height above sea level correction of atmospheric pressure: 0.9

Vehicle speed sensor: 0 km/h

Engine speed: 0 rpm

Target idle speed: 0 rpm

Evaporator temperature: 10.0 °C

Power steering pressure switch:

A/C selection: Off

A/C relay: Off

A/C pressure switch: Off

O2 sensor 1, bank 1: 0.13 V

O2 sensor 2, bank 1: 0.42 V

Ignition angle cylinder 1: 3.4 °

Ignition angle cylinder 2: 3.4 °

Ignition angle cylinder 3: 3.4 °

Ignition angle cylinder 4: 3.4 °

Injection time cylinder 1: 2.8 ms

Injection time cylinder 2: 2.7 ms

Injection time cylinder 3: 2.7 ms

Injection time cylinder 4: 2.8 ms

Injection time bank 1: 2.9 ms

Start injection angle: -7.9 °

Fuel cut-off sequence value: 0

Close loop control: Yes

Injection closed control correction: 6.1 %

Injection closed control correction average: -1.2 %

Injection adaptive addition coefficient: 0.1 ms

Injection adaptive multiplication coefficient: -1.6 %

O2 sensor 1, bank 1 heater duty cycle: 93.0 %

Stepper motor position: 39 steps

Stepper motor position: 49.6 %

Idle stepper motor opening regulation: 3.5 %

Idle stepper motor opening adaption: 8.4 %

Stepper motor actual position: 39 steps

Stepper adaptive opening at A/C: 0.0 %

Evaporative emission (EVAP) system, canister purge valve: 0.0 %

Canister saturation: 0.3

Cooling fan: 0

Engine status: Idle speed

Ignition dwell time: 3.9 ms

Injection time correction at idle: 0.0 ms

Check engine telltale

Throttle closed

Fuel pump

A/C relay

Throttle keeping close

Cooling fan high speed

Cooling fan low speed

Power supply relay

Evaporative emission (EVAP) system, canister purge valve

Idle speed actuator

Ignition coil

Stop all actuators

Resetting adaptive values