Car, LIFAN, 320 SMILY, Suntech engine (ECM)
Engine - Suntech engine (ECM) - 0
Identification
Part number: 0E002--
Serial number: 65535
Engine type:
DTC
P0508: Unknown DTC
P0037: O2 sensor 2, bank 1 heater - circuit low voltage
P0650: Check engine telltale - circuit malfunction
P0261: Injector cylinder 1 - circuit low voltage
P0270: Injector cylinder 4 - circuit low voltage
Controls
Clear DTC
Data stream
Battery voltage: 14.43 V
Other diagnostic voltage modes: Active
Ignition switch: On
Battery disconnect: No
Voltage jump: Off
Information bit for battery disconnection: No
OBD-I diagnostic voltage mode: Active
OBD-II diagnostic voltage mode: Active
Engine coolant temperature sensor: 1.35 V
Engine coolant temperature sensor: 84.0 °C
Intake air temperature sensor: 2.17 V
Intake air temperature sensor: 57.8 °C
Throttle position sensor: 0.49 V
Throttle position sensor: 0.0 °
Throttle position sensor adaptation (close): 11.7 °
MAP sensor: 1.25 V
Mass air flow sensor: 8.0 kg/h
MAP sensor: 30.4 kPa
Positive height above sea level correction of atmospheric pressure: 0.9
Vehicle speed sensor: 0 km/h
Engine speed: 0 rpm
Target idle speed: 0 rpm
Evaporator temperature: 10.0 °C
Power steering pressure switch:
A/C selection: Off
A/C relay: Off
A/C pressure switch: Off
O2 sensor 1, bank 1: 0.13 V
O2 sensor 2, bank 1: 0.42 V
Ignition angle cylinder 1: 3.4 °
Ignition angle cylinder 2: 3.4 °
Ignition angle cylinder 3: 3.4 °
Ignition angle cylinder 4: 3.4 °
Injection time cylinder 1: 2.8 ms
Injection time cylinder 2: 2.7 ms
Injection time cylinder 3: 2.7 ms
Injection time cylinder 4: 2.8 ms
Injection time bank 1: 2.9 ms
Start injection angle: -7.9 °
Fuel cut-off sequence value: 0
Close loop control: Yes
Injection closed control correction: 6.1 %
Injection closed control correction average: -1.2 %
Injection adaptive addition coefficient: 0.1 ms
Injection adaptive multiplication coefficient: -1.6 %
O2 sensor 1, bank 1 heater duty cycle: 93.0 %
Stepper motor position: 39 steps
Stepper motor position: 49.6 %
Idle stepper motor opening regulation: 3.5 %
Idle stepper motor opening adaption: 8.4 %
Stepper motor actual position: 39 steps
Stepper adaptive opening at A/C: 0.0 %
Evaporative emission (EVAP) system, canister purge valve: 0.0 %
Canister saturation: 0.3
Cooling fan: 0
Engine status: Idle speed
Ignition dwell time: 3.9 ms
Injection time correction at idle: 0.0 ms
Actuators test
Controls
Check engine telltale
Throttle closed
Fuel pump
A/C relay
Throttle keeping close
Cooling fan high speed
Cooling fan low speed
Power supply relay
Evaporative emission (EVAP) system, canister purge valve
Idle speed actuator
Ignition coil
Stop all actuators
Utility
Controls
Resetting adaptive values