Bil, SUBARU, FORESTER, CB18 - Engine

System: 2.0 DIESEL

P0617: Starter relay - circuit high voltage

P0201: Ukendt fejlkode

P0102: Mass or volume air flow (MAF) sensor - circuit low voltage

Clear DTC

Distance since check engine telltale on: 65535 km

Fuel pressure on fuel rail (Gauge): 128.840 MPa

Kommando for EGR-ventil: 10 %

EGR error: 99.2 %

Canister purge control: 25 %

Brændstofniveau: 12.9 %

Warm-up count: 77

Afstand siden fejlkode slettet: 12901 g/sek

Trykføler til brændstoftank: 99 Pa

Barometrisk tryk føler: 170 kPa

Catalyst temperature sensor 1, bank 1: 75.0 %

Catalyst temperature sensor 2, bank 1: 80.0 %

Catalyst temperature sensor 1, bank 2: 60.0 %

Batteri spænding: 13.9 V

Absolute load value: 9.80 %

Target equivalence ratio: 1.47

Throttle valve relative position: 69 %

Ambient temperature: -4 °C

Gasspjældpositionsføler 2: 10 %

Speeder pedal positions føler N1: 10 %

Speeder pedal position N2: 50 %

Target throttle position: 20.0 %

Time since check engine telltale on: 12884 min

Time since DTC clear: 12901 min

Type of fuel: Udefineret

EVAP system vapor pressure: 45.15 kPa

Vapor pressure fuel tank sensor: 12.884 kPa

Long term fuel trim O2 sensor 2, bank 1: 19.53 %

Relative accelerator pedal position: 25 %

Oil temperature: 105 °C

Engine fuel rate: 111.00 L/h

Motordrejningsmoment: 52 %

Engine torque reference: 222 L/h

A/T status: --

Intake air temperature sensor 1, bank 1: -- °C

Intake air temperature sensor 1, bank 2: -- °C

Intake air temperature sensor 1, bank 3: -- °C

Intake air temperature sensor 2, bank 1: -- °C

Intake air temperature sensor 2, bank 2: -- °C

Intake air temperature sensor 2, bank 3: -- °C

Motorens friktionsmoment: 55 L/h

Engine Exhaust Flow Rate: 333 kg/h

Cylinder fuel rate: 305 mg/slag

Belastning Motor: 50.2 %

Motor kølevæske temperatur føler: 97 °C

MAP føler: 100.0 kPa

Motor Hastighed: 900.0 Omdr.

Køretøjets hastighed sensor: 14 km/h

Intake air temperature sensor: 20 °C

Luft masse måler: 90.0 g/sek

Gasspjældsposition: 33.333 %

: 07:57:52

Control module voltage: 12.54 V

Luft-/brændstofforhold: 29.2 :1

Ambient temperature sensor: 55 °C

Luft masse måler: 0.52 V

Indsprøjtnings tid B1: 0.0 ms

Learned ignition angle: 0.0 °

Gaspedalposition: 68.2 %

EGR step position: 0 steps

Alternate duty ration: 18 %

Intake OCV duty right: 0.0 %

Intake OCV duty left: 0.0 %

Intake OCV current right: 0.0 mA

Intake OCV current left: 0.0 mA

A/F Føler 1, bank 1: -16.0 mA

A/F Føler 1, bank 1: 0 Ohm

Air/Fuel ratio sensor 1, bank 1: 0.0

Electronic throttle control (ETC) motor duty: -100.0 %

Actual throttle position: -50 °

Memorized cruise control: 21 km/h

Kilometer tæller: 0 km

Oil temperature: -40 °C

Roughness monitor #1: 0

Roughness monitor #2: 0

Roughness monitor #3: 0

Roughness monitor #4: --

Knock correction: -32.0 °

Target idle speed: 0.0 Omdr.

Target throttle position: -50 °

Batteristrøm: -128 A

Batteritemperatur: -40 °C

AT vehicle ID: Sluk

Delivery mode connector: Sluk

Neutral switch: Not neutral

Idle speed position switch: Not idle

Ignition switch: Sluk

A/C-kontakt: Sluk

Starter switch: Sluk

Rear O2 rich signal: Mager

Knocking signal: Sluk

Crankshaft position signal: Sluk

Crankshaft position signal: Sluk

Bagrudeafdugningskontakt: Sluk

Blower switch: Sluk

Light switch: Sluk

Wiper switch: Sluk

A/C pressure switch midle: Sluk

AC compressor: Sluk

Radiator fan relay 1: Sluk

Radiator fan relay 2: Sluk

Cruise control "Cancel" switch: Sluk

TGV output: Sluk

TGV drive: Lukket

Retard signal from AT: Sluk

Fuel cut-off signal from AT: Sluk

Ban of torque down: Tænd

Request torque down VDC: Sluk

Torque permission signal: Sluk

Electronic throttle control (ETC) motor relay: Sluk

Cruise "Set/Coast" switch: Sluk

Cruise control "Resume/Accelerate" switch: Sluk

Bremsepedalkontakt: Sluk

Main switch: Sluk

Cruise control "Cancel" switch: Sluk

Oil level switch: Low level

Fuel cut-off: Sluk

Shift pattern demand for low water temperature: Sluk

Manifold relative pressure: -128 kPa

Electronic throttle control (ETC) motor: 0.00 V

Sub-throttle sensor: 0.00 V

Main throttle sensor: 0.00 V

Accelerator pedal position sensor (sub): 0.00 V

Electronic throttle control (ETC) motor duty: -100.0 %

TGV position switch 1: Åben

TGV position switch 2: Åben

Fuel level resistance: 0.0 Ohm

X mode: Sluk

SI drive mode:

Belastning Motor: 50.2 %

Motor kølevæske temperatur føler: 97 °C

MAP føler: 100 kPa

Motor Hastighed: 900 Omdr.

Køretøjets hastighed sensor: 14 km/h

Intake air temperature sensor: 20 °C

Luft masse måler: 90.00 g/sek

Gasspjældsposition: 33.3 %

Engine running time: 28672 sek

Luft masse måler: 0.5 V

Differential pressure sensor: 1.42 V

Indsprøjtnings tid B1: 0.00 ms

Indsprøjtnings tid B2: 17.66 ms

Learned ignition angle: -64.0 °

Gaspedalposition: 68.2 %

Fuel temperature: -40 °C

Front O2 sensor heater 1: 8.55 A

Rear O2 heater: 2.902 A

Front O2 sensor heater 2: 0.55 A

Radiator fan: 92 %

Primary control: 0.0 %

Secondary control: 29.8 %

Canister purge duty cycle: 0 %

TGV position sensor right: 2.580 V

TGV position sensor left: 2.860 V

EGR step position: 0 steps

Generator duty cycle: 18 %

Fuel pump duty cycle: 60.0 %

Intake VVT advance angle left: -50 °

Intake VVT advance angle right: -50 °

Intake OCV duty right: 0.0 %

Intake OCV duty left: 0.0 %

Intake OCV current right: 0 mA

Intake OCV current left: 0 mA

A/F Føler 1, bank 1: -16.00 mA

A/F Føler 2, bank 1: -4.37 mA

A/F Føler 1, bank 1: 0 Ohm

A/F Føler 2, bank 1: 95 Ohm

Air/Fuel ratio sensor 1, bank 1: 0.00

Air/Fuel ratio sensor 2, bank 1: 1.08

A/F correction #3: -5.00 %

A/F sensor learning value 3: 94.53 %

Rear O2 sensor: 1.38 V

A/F sensor voltage: 2.98 V

Radiator fan 1 duty: 466 %

Radiator fan 2 duty: 244 %

Purge line pressure: 64.50 kPa

Glow control unit duty: 1288.4 %

Rear O2 sensor input voltage: 23.30 V

Rear O2 sensor offset voltage: 24.30 V

Rear O2 sensor input voltage 2: 1.36 V

Rear O2 sensor offset voltage 2: 1.36 V

A/F sensor 1, bank 1 heater: 3.8 A

A/F sensor 2, bank 1 heater: 3.0 A

Waste gate position sensor: 1.680 V

Turbocharger Wastegate Learned Closed Position: 5.78 mm

Actual wastegate valve position: -7.34 mm

Target wastegate valve position: -7.34 mm

Air bypass valve: Ctabe

SI drive mode: Ikke defineret

Throttle closed position: 2.52 V

Electronic throttle control (ETC) motor duty: -100.0 %

Actual throttle position: -50 °

Roughness monitor #1: 0

Roughness monitor #2: 0

Roughness monitor #3: 0

Roughness monitor #4: 0

Roughness monitor #5: 15

Roughness monitor #6: 0

Learned ignition timing correction amount: 8.00

Knock correction: -32.0 °

Main injection period: 2.0 °

Final fuel injection amount: -- mm³/stk

Number injections: 0

Target intake manifold pressure: 0 kPa

Brændstofpumperelæ

Evaporative emission (EVAP) system, canister purge valve

Radiator fan 1 relay

A/C compressor relay

Brake vacuum pump relay