Bil, SSANGYONG, Rexton G4 (Y400), G20DTR (ECM)

Dele nummer: --

Stel nr.: qwertyuiopasdfghg

Clear DTC

Drive position: D

A/C-kontakt: Tænd

A/C compressor status: Ja

Condition Fuel Cut Off: Ja

Throttle position at idle position: Ja

Throttle wide open position: Ja

Ignition status: Tænd

Fuel pump control: Tænd

Main relay status: Tænd

Clutch switch: Åben

Bremsepedalkontakt: Nedtrykket

Camshaft control: Aktiveret

Engine running detected: Ja

Batteri spænding: 25.5 V

Indsugningsmanifoldtryk: -- hPa

Gasspjælds positions føler: -- %

Accelerator pedal position sensor signal: -- %

Motor kølevæske temperatur føler: -- °C

Coolant temperature at engine start: -- °C

PWM: -- %

Indsugningslufttemperatur: -- °C

Motorolietemperatur: -- °C

Ambient temperature: -- °C

Ambient pressure: -- hPa

Gear engaged: --

A/C pressure: -- hPa

Køretøjs hastighed : -- km/h

Lambda sonde / O2 sensor 2, bank 1: -- V

O2 sensor correction: --

Fuel adaptation, idle active, bank 1: -- %

Fuel adaption (part load): --

Target air/fuel ratio: --

Purge control valve duty: -- %

Ignition 1 output: -- kW

Ignition 2 output: -- kW

Ignition 3 output: -- kW

Injection timing of all cylinders: -- ms

Motor Hastighed: -- Omdr.

Target idle speed: -- Omdr.

Belastning Motor: -- %

Engine running time: -- min

Fuel consumption: -- ms

Turbocharger boost control solenoid valve feedback: 80.00 V

Systemspænding: 25.5 V

CAN transmit error counter (TEC): 255

CAN receive error counter (REC): --

CAN-bus OFF counter: --

Cruise control main switch: Tænd

Cruise control/speed limiter: status of the "Cancel/Resume" button: Tænd

Cruise control "Set" button: Tænd

Cruise control "Plus" button: Tænd

Cruise control "Minus" button: Tænd

Cruise control "Acceleration" button: Tænd

Cruise control "Deceleration" button: Tænd

Cruise control "Resume" button: Tænd

State of cruise control or speedlimiter:

Check motor fejllampe

A/C compressor relay

Fuel open loop

Canister purge valve

ETC Motor

Ignition coil, cylinder 1

Ignition coil, cylinder 2

Ignition coil, cylinder 3

Ignition coil, cylinder 4

Disable fuel injection 1

Disable fuel injection 2

Disable fuel injection 3

Disable fuel injection 4

Intake oil control valve

Exhaust oil control valve

Turbocharger actuator position

Rediger stel nr.

ECU registration

Auto detection trigger

Redigere konfiguration

Edit parameter configuration