Car, TAGAZ, S1 REIN C190, Engine (ECM)

Vehicle manufacturer specific: 1026301GB04

Supplier ECU software number: EC000802A

Engine type: HFC4GA

P1336: Crankshaft position system variation not learned

Clear DTC

Calculated load value: 51.8 %

Engine coolant temperature sensor: 89 °C

Short term fuel trim bank 1: -71.9 %

Long term fuel trim bank 1: -21.1 %

MAP sensor: 88 kPa

Engine speed: 1000.0 rpm

Vehicle speed sensor: 84 km/h

Ignition angle cylinder 1: 26.5 °

Intake air temperature sensor: 32 °C

Absolute throttle position A: 20.8 %

O2 sensor 1, bank 1: 1.109 V

Short term fuel trim O2 sensor 1, bank 1: -71.1 %

O2 sensor 2, bank 1: 1.109 V

Distance since check engine telltale on: 8532 km

A/C request: Off

A/C clutch: Off

Catalyst protection mode: Off

Low fuel telltale: On

Check engine telltale: Off

Power enrichment: Off

Close loop control: On

Knock control (B1): Not present

Cooling fan low speed: Off

Cooling fan high speed: On

Battery voltage: 6.96 V

Target idle speed: 725.0 rpm

Barometric pressure sensor: 53.5 kPa

Air/Fuel ratio: 8.6 :1

Engine running time: 9044 sec

Mass air flow sensor: 4.0 g/sec

O2 sensor 1, bank 1 lean/rich time: 340 Counts

O2 sensor 1, bank 1 rich/lean to lean/rich response ratio: 0.2 :1

O2 sensor 1, bank 1 rich/lean time: 327 Counts

O2 sensor 1, bank 1 lean/rich time: 2272.7 ms

O2 sensor 1, bank 1 rich/lean time: 10543.5 ms

O2 sensor 1, bank 1 lean/rich average time: 2.6 ms

O2 sensor 1, bank 1 rich/lean average time: 18.6 ms

Catalyst monitor idle test status:

Catalyst monitor idle last test result time: 13.3 sec

Check engine telltale

Fuel pump

Cooling fan low speed

Cooling fan high speed

A/C relay

Evaporative emission (EVAP) system, canister purge valve

Idle speed actuator

Idle rpm control

Ignition angle

Injectors

Reset idle speed actuator

ECU learn reset

Crankshaft sensor adaptation