Car, KIA, General, CEE'D (ED), 2012, D 1.6 TCI-U2, D 1.6 TCI-U2 - ISG(+), CPF(+) (ENGINE)
D 1.6 TCI-U2 - ISG(+)/CPF(+) (ENGINE) - 0
Identification
Vehicle manufacturer ECU hardware number: 39120-2A051-----
ROM ID: --
DTC
Controls
Clear DTC
Data stream
Accelerator pedal position sensor: 100.0 %
Fuel pressure: 2000000.0 hPa
Mass air flow sensor: 3276.0 mg/strk
EGR valve: 100.0 %
Barometric pressure sensor: 3500.0 hPa
Intake air temperature: 200.0 °C
Water temperature: 200.0 °C
Brake pedal switch 1: On
Blower switch: On
A/C pressure low switch: On
Ignition switch: On
Clutch switch (M/T only): On
A/C switch: On
Brake pedal switch 2: On
Gearbox neutral position status signal: On
Accelerator pedal position sensor 1: 5000.0 mV
Accelerator pedal position sensor 2: 5000.0 mV
Check engine telltale: On
Glow plug relay: 100.0 %
Fuel quantity: 99.6 mm³
Battery voltage: 25.78 V
Vehicle speed: 300.0 km/h
Mass air flow sensor: 1000.0 kg/h
Engine cooling fan-Low: On
Engine cooling fan-High: On
Boost pressure sensor: 3500.0 hPa
VGT actuator: 100.0 %
Fuel temperature sensor: 200.0 °C
After run:
PTC heater relay: On
Immobilizer telltale: On
Engine speed: 0.0 rpm
Output of fuel metering unit (MPROP): -- %
A/C pressure sensor: -- psi
A/C pressure sensor: -- mV
Variable swirl actuator: -- %
Exhaust temperature sensor 2 (CPF option): -- mV
Diesel Particulate filter (DPF) differential pressure sensor: -- mV
Inlet throttle actuator: -- %
Equivalence ratio (lambda) sensor 1, bank 1: --
ECU adaption status: -- %
Oil level filtered value: -- mm
Oil level filtered value: -- mm
Oil temperature sensor: -- °C
Oil level average value: -- mm
Oil level: --
Diesel Particulate filter (DPF) differential pressure sensor: 32767.0 hPa
Exhaust gas temperature value before VGT (CPF option): 1300.0 °C
Diesel Particulate filter (DPF) inlet temperature: 1300.0 °C
Pressure before diesel particulate filter (DPF) (CPF option): 32767.0 hPa
Calculated load value: 100.0 %
Boost pressure sensor: 5000.0 mV
Intake air temperature sensor: 200.0 °C
Mass air flow sensor: 10000.0 kg/h
Linearised rail pressure: 2000000.0 hPa
Mass air flow per cylinder: 3276.0 mg/strk
Injection quantity: 100.0 mm³
Control deviation of the exhaust-gas recirculation control: 1000.0 mg/strk
Swirl flap - duty cycle: 100.0 %
Status of system lamp: On
Check engine telltale: On
Actual engine temperature: 200.0 °C
Vehicle acceleration: 32.0 m/s²
Actual injection quantity: 100.0 mm³
Vehicle transmission type: A/T
Cruise control: On
Status of TCS request: On
Status of MSR request: On
Status of ABS request: On
Torque reduction request from TCS: 100.0 %
Torque reduction request from MSR: 100.0 %
Average engine speed: 7500.0 rpm
Throttle position angle: 100.0 %
Glow control actuator relay output: 100.0 %
Raw value intake air temperature in volt: 5000.0 mV
Desired injection quantity (MI1): 100.0 mm³
Target injection quantity (Pilot 1): 100.0 mm³
Target injection quantity (Pilot 2): 100.0 mm³
Target injection quantity (Pilot 3): 100.0 mm³
Target injection quantity (post 1): 100.0 mm³
Target injection quantity (post 2): 100.0 mm³
Injection quantity: 100.0 mm³
Raw peak value of rail pressure: 5000.0 mV
Distance since check engine telltale on: 4294967295 km
Main relay error counter: 255
Time since check engine telltale on: 4294967295 min
Variable swirl position: 100.0 %
Swirl flap - duty cycle: 100.0 %
Variable swirl actuator - first learnt value: 100.0 %
Variable swirl actuator - last learnt value: 100.0 %
Diesel Particulate filter (DPF) differential pressure: 32767.0 hPa
Starter ON signal: Yes
ISG system built-in(ISG): Yes
Starter request by key: Yes
ISG Status(ISG): On
Clutch is pushed more than 10%: Yes
AMS stop reason - blower max switch (AMS): Yes
Idle stop request by drivers demand(ISG): Yes
Gear is on neutral position: Yes
Driver`s Seat Belt: Unbelted
Driver door status: Open
Engine hood switch: Open
Battery current (AMS): -0.1 A
Battery voltage (AMS): 71.53 V
Battery temperature (AMS): 32727.5 °C
State of battery charge (AMS): 255 %
State of health of battery (AMS): 255 %
State of function of battery (AMS): 12.750 V
Brake boost vacuum pressure: -0.039 hPa
Brake boost vacuum pressure voltage: 314.57 V
Nominal capacity (AMS): 255 Ah
No idle stop by ISG component error: True
No idle stop by fuel system: True
No idle stop by operation data: True
No idle stop by torque system: True
No idle stop by air conditioning system: True
No idle stop by exhaust system: True
No idle stop by invalid battery sensor data: True
No idle stop by vehicle speed condition: True
No idle stop by ISG inhibit switch: True
No idle stop by engine temperature: True
No idle stop by high engine speed: True
No idle stop by safety driver door seat belt hood switch: True
No idle stop by regeneration: True
No idle stop by time since the engine start to low: True
Actuators test
Controls
A/C compressor relay
Check engine telltale
PTC heater relay
Cooling fan high speed
Cruise Control Main Lamp(Option)
Cruise Control SET Lamp(Option)
Glow Control Lamp
Glow plug relay
Immobilizer telltale
Boost Pressure Actuator 5%
Boost Pressure Actuator 95%
EGR valve 5%
EGR valve 95%
Throttle valve actuator 5%
Throttle valve actuator 95%
Variable swirl control actuator 5%
Variable swirl control actuator 95%
Cooling fan low speed
ISG Inhibit Lamp
ISG test (Option)
Accelerator pedal 5%
Accelerator pedal 95%
EGR cooling by pass 5%
EGR cooling by pass 95%
Utility
Controls
Injectors replacement
Compression test
Idle speed comparison
Injection quantity comparison
ECU Change (CPF option)
Lambda sensor change
Fuel rail pressure sensor replacement
Air Flow Sensor Change
CPF Change (CPF option)
Differential pressure sensor replacement (CPF option)
Swirl flap replacement
Throttle adaptation reset
EGR valve change
APS module change
CPF Service Regeneration (CPF option)