Bil, HYUNDAI, General, H-1, IMAX, ILOAD, GRAND STAREX (TQ), 2012, G 2.4 DOHC, G 2.4 DOHC - Unleaded EOBD (ENGINE)

G 2.4 DOHC - Unleaded EOBD (ENGINE) - 0

Identifikation

Software version bootloader:

ECU software version number:

Calibration ID:

Fejlkoder

Controls

Clear DTC

Levende Data

A/C-kontakt: Sluk

Variant coding: M/T

Gear shift 'D' range: Sluk

A/C status: Sluk

Check motor fejllampe: Sluk

AC compressor: Sluk

Ignition switch: Sluk

Brændstofpumpe: Sluk

Throttle closed position: Sluk

Main relay: Sluk

Throttle full open: Sluk

Camshaft and crankshaft synchronization: Sluk

Fuel cut-off: Sluk

Cranking signal: Sluk

Fuel system status: Sluk

Knocking detection: Sluk

Cranking signal: Sluk

CVVT actuation status: Sluk

O2 sensor 2, bank 1 operation: Sluk

O2 sensor 1, bank 1 operation: Sluk

Drive status: Tænd

Canister purge state: Tænd

Canister purge phase: Tænd

Idle rpm control: Tænd

Belastning Motor: 1535.9 %

Gasspjælds positions føler: 4.98 V

Throttle position PWM servo signal: 100.0 %

Adapted throttle position sensor: 20.4 °

Batteri spænding: 17.37 V

Motor kølevæske temperatur føler: 143.2 °C

Engine coolant temperature sensor (model): 143.2 °C

Intake air temperature sensor: 143.2 °C

Tank luft ventil: -- %

Injection time cylinder 1: -- ms

Injection time cylinder 2: -- ms

Injection time cylinder 3: -- ms

Injection time cylinder 4: -- ms

Torque request from TCU: 100.0 %

O2 sensor 1, bank 1 heating time: 2550 ms

O2 sensor 2, bank 1 heating time: 2550 ms

Lambda sonde / O2 sensor 1, bank 1: 1.330 V

Lambda sonde / O2 sensor 2, bank 1: 1.330 V

Target idle speed: 2550 Omdr.

Idle speed actuator: 100.0 %

idle speed actuator offset: 100.0 %

Motor Hastighed: 16383.8 Omdr.

Motorolietemperatur: -- °C

Tændings vinkel: -- °

Køretøjs hastighed : -- km/h

Kortsigtet brændstofafstemning række 1: -0.0 %

Long term fuel trim (idle): -- %

Long term fuel trim (part load): -- %

Knock adaption cylinder 1: -- °

Knock adaption cylinder 2: -- °

Knock adaption cylinder 3: -- °

Knock adaption cylinder 4: -- °

CVVT adaption PWM: -- %

CVVT duty control status: --

Inlet CAM position: -- °

Target camshaft position: -- °

CVVT valve duty: -- %

Udgangs test

Controls

Check motor fejllampe

Brændstofpumperelæ

A/C compressor relay

Main relay

Evaporative emission (EVAP) system, canister purge valve

Idle Speed Control Actuator

Oil control valve (CVVT)

Cooling fan high speed

Cooling fan low speed

Immobilizer telltale

indsprøjtnings dyser

Muligheder

Controls

Auto detected configuration reset

Resetting adaptive values

Cylinder Power Balance (Option)

CVVT Test

Idle RPM Control Test(ISC Type Only)