Bil, HYUNDAI, General, I30 , ELANTRA NEOS (FD), 2010, G 2.0 MPI, G 2.0 MPI - Leaded All (ENGINE)
G 2.0 MPI - Leaded All (ENGINE) - 0
Identifikation
Software version bootloader:
ECU software version number: --
Calibration ID:
Fejlkoder
Controls
Clear DTC
Levende Data
A/C-kontakt: Tænd
Vehicle transmission type: A/T
A/C status: Tænd
Cooling fan high speed: Tænd
AC compressor: Tænd
Tændingsspænding: Tænd
Cooling fan low speed: Tænd
Brændstofpumpe: Tænd
Throttle closed position: Tænd
Main relay: Tænd
Throttle full open: Tænd
Camshaft and crankshaft synchronization: Tænd
Fuel cut-off: Tænd
Starting status: Tænd
Knocking detection: Tænd
Canister purge state: Tænd
MAP føler: 319.81 V
MAP føler: 2560.0 hPa
Gasspjælds positions føler: 4.98 V
Throttle position PWM servo signal: 100.0 %
Adapted throttle position sensor: 98.3 %
Motor Hastighed: 10200 Omdr.
Batteri spænding: 17.37 V
Motor kølevæske temperatur føler: 143.2 °C
Engine coolant temperature sensor (model): -- °C
Intake air temperature sensor: -- °C
Tank luft ventil: -- %
Relative fuel injection quantity of canister control: -- %
Injection time cylinder 1: -- ms
Injection time cylinder 2: -- ms
Injection time cylinder 3: -- ms
Injection time cylinder 4: -- ms
Actual torque: 100.0 %
Target idle speed: 2550 Omdr.
Idle speed actuator: 100.0 %
Motor Hastighed: 16383.8 Omdr.
Motorolietemperatur: -- °C
Calculated oil temperature: -- °C
Ignition angle cylinder 1: -- °
Ignition angle cylinder 2: -- °
Ignition angle cylinder 3: -- °
Ignition angle cylinder 4: -- °
Køretøjs hastighed : -- km/h
Ignition dwell time: 262.1 ms
Camshaft position: 155.6 °
Target camshaft position: 155.6 °
CVVT status: -
CVVT actuation status: Adjust
CVVT valve duty: 100.0 %
CVVT duty control status: -
Udgangs test
Controls
Check motor fejllampe
Brændstofpumperelæ
A/C compressor relay
Fuel pump control
Immobilizer telltale
Cooling fan high speed
Cooling fan low speed
Main relay
Evaporative emission (EVAP) system, canister purge valve
Idle speed actuator
Intake oil control valve
Ignition coil cylinder 1+4
Ignition coil cylinder 2+3
indsprøjtnings dyser
Muligheder
Controls
Resetting adaptive values
Rediger stel nr.
Idle CO adjustment
Idle RPM Control Test(ISC Type Only)