Bil, CITROEN, DS3, 5FX - MED17.4 Euro4

PSA reference: 96 63 71 15 80

ECU manufacturer: Bosch

Additional number: 96 66 31 91 80

Softwareversion: 16 17

Software reference: 00 01 95

Stel nr.: VF7SA5FX8BW587211

Motortype: 5FX

Model: DS3

P0599: Thermostat heater control system - circuit short to battery

Clear DTC

Injection time cylinder 1: 1.2 ms

Injection time cylinder 2: 0.0 ms

Injection time cylinder 3: 0.0 ms

Injection time cylinder 4: 0.0 ms

Lambda sonde / O2 sensor 2, bank 1: Fed

Lambda sonde / O2 sensor 2, bank 1: 0.410 V

Lambda sonde / O2 sensor 1, bank 1: Mager

Lambda sonde / O2 sensor 1, bank 1: 0.000 V

O2 sensor 1, bank 2 loop control: Lukket sløjfe

O2 sensor 2, bank 1 loop control: Åben sløjfe

O2 sensor 1 heater duty cycle: 90.0 %

O2 sensor 2 heater duty cycle: 70.0 %

Upstream mixture correction factor: -6.7 %

Downstream mixture correction factor: 0.0 %

Canister electrovalve duty cycle: 58 %

Evaporative emission (EVAP) system - canister load: 0 %

Maximum ignition angle: 22 °

Minimum ignition angle: -11 °

Ignition angle cylinder 1: 1 °

Ignition angle cylinder 2: 1 °

Ignition angle cylinder 3: 1 °

Ignition angle cylinder 4: 1 °

Knock retard angle cylinder 1: 0 °

Knock retard angle cylinder 2: 0 °

Knock retard angle cylinder 3: 0 °

Knock retard angle cylinder 4: 0 °

Motor Hastighed: 712 Omdr.

Køretøjets hastighed sensor: 0 km/h

Speeder pedal positions føler N1: 0.400 V

Speeder pedal position N2: 0.200 V

Recalculated accelerator position: 0.0 %

Cruise control/speed limiter: 0 km/h

Brake pedal switch 1: Udløst

Brake pedal switch 2: Udløst

Clutch position sensor: Nedtrykket

Accelerator pedal point of resistance sensor: Udløst

Gear engaged: Frigear

Motor status: Sluk

Engine operation: Excessive engine speed

Fartpilot: Inaktiv

Hastighedsbegrænser: Inaktiv

Required engine speed: 700 Omdr.

Intake air temperature sensor: 28 °C

Motor kølevæske temperatur føler: 93 °C

Engine coolant temperature reference: 84 °C

Cooling fan high speed relay: Inaktiv

Cooling fan low speed relay: Inaktiv

A/C request: Ja

Generator progressive charge reference: 0 ms

Compressor power relief reference: Clutch

Refrigerant circuit pressure: 9.3 bar

Batteri spænding: 13.80 V

Generator: 37 %

Accelerator pedal position sensor supply voltage: 4.970 V

Oil pressure switch:

Power supply relay: Controlled

Reference air quantity corrected: 16 %

Unprocessed measured air quantity: 16 %

Unprocessed reference air quantity: 19.8 %

Measured air quantity corrected: 20.3 %

Luft masse måler: 25.5 kg/h

Reference manifold pressure: 1280 mbar

Measured manifold pressure: 2550 mbar

Throttle position sensor measured value: 0 °

Throttle position sensor voltage copy 1: 180 mV

Throttle position sensor voltage copy 2: 100 mV

Inlet camshaft dephaser position reference value: 68.0 °

Inlet camshaft dephaser position measurement: -171.0 °

Inlet camshaft dephaser electrovalve duty cycle: 84 %

Required air flow: 7.8 kg/h

Accelerator pedal min position learning 1: 0.4138 V

Accelerator pedal min position learning 2: 0.4162 V

Learning of the accelerator pedal max position 1: 3.5498 V

Learning of the accelerator pedal max position 2: 3.5437 V

Adaptation of crankshaft target under deceleration: Lærer

Operating zones initialised: 41 %

Friction torque adaptive values in relation to the coolant temperature: 99.8 %

Throttle limits learning status: Done

Learning limp home position 1: 0.003 V

Learning limp home position 2: 54.543 V

Learning throttle min stop position track 1: 0.566 V

Learning throttle min stop position track 2: 4.414 V

Indicated engine torque adaptive values: 2534.7 kg/h

Mixture at idle adaptive values: 0.4 %

Transitory mixture adaptive values: 29.9 %

Downstream sensor mixture adaptive values: 99.8 %

Knock adaption cylinder 1: 0 °

Knock adaption cylinder 2: 0 °

Knock adaption cylinder 3: 0 °

Knock adaption cylinder 4: 0 °

Engine torque obtained by managing ignition angle (setting): 0 %

Engine torque obtained by managing air flow (setting): 1 %

Engine torque obtained by managing ignition angle (actual): 0 %

Engine torque obtained by managing air flow (actual): 1 %

Estimated resistive torque: 6 %

Driver requirement torque: 0 %

Turbocharging pressure reference value: 940 mbar

Barometrisk tryk føler: 990 mbar

Wastegate electrovalve duty cycle: 89 %

Dump valve duty cycle: 0 %

Turbo additional coolant pump control status: Controlled

Additional ventilation under bonnet (VASC): Not control

Trykføler for brændstoffordelerrør: 49 bar

Fuel rail measured pressure: 48 bar

Fuel pressure regulator control duty cycle: 13 %

Turbocharging pressure measured: 970 mbar

Locking of the ECU: Låst

Statspærrestatus: Programmed 2 times

Problem detected when transmitting the unlock code: Awaiting response from BSI

Ignition coil 1

Ignition coil 2

Ignition coil 3

Ignition coil 4

Electronic throttle control (ETC)

Evaporative emission (EVAP) system, canister purge valve

Cooling fan high speed

Cooling fan low speed

Power supply relay

Additional heating

Additional ventilation under bonnet (VASC)

Turbocharger control solenoid valve

Turbocharger wastegate solenoid

Turbo cooling coolant pump control

Coolant pump

Thermostat test

ECU learn reset