Car, CHANGAN, CS35 Plus New, Electronic parking brake (EPB)
Brake system - Electronic parking brake (EPB) - 0
Identification
Calibration version: 1124456789@ABCDEFGHI
Diagnostic defined version info: 1124
ECU software version number: 1124
Serial number: 1124456789@ABCDEFGHI
Fingerprint identification: 4456
FBL software version number: 1124
Bootstrap software document version: 1124
Software partnumber: 1124456789@ABCDEFGHI
VIN no: 1124456789@ABCDEF
Supplier identification: 1124456
Part number: 1124456789@ABCDEFGHIQ
Changan defined ECU software version number: 11244567
Changan defined ECU hardware version number: 11244567
DTC
Controls
Clear DTC
Data stream
Vehicle speed: 0.0 km/h
Supply voltage: 4.9 V
Steering wheel angle sensor: 550.94 °
Right rear wheel speed sensor: 1259.3 km/h
Right front wheel speed sensor: 1259.3 km/h
Longitudinal acceleration sensor: 123.53 g
Left rear wheel speed sensor: 1259.3 km/h
Left front wheel speed sensor: 1259.3 km/h
Lateral acceleration sensor: 124.69 g
Brake pressure sensor: 125.93 bar
Auto hold status: Open
Brake light system (BLS) signal: Open
ESP switch: Off
Hill descent control switch: On
ABS warning telltale: Closed
Auto hold switch indicator: Closed
AUTO HOLD telltale: Closed
EBD telltale: Open
ESC off telltale: Open
ESC telltale: Off
Hill descent control telltale: Green
Steering wheel angular velocity: 36.02 °/sec
ABS: Open
Cruise control: Open
Active yaw control: Open
EBD control: Closed
Brake torque:
Hill start assist control (HAC): Closed
Hydraulic brake assistant: Open
Traction control: Closed
Auto emergency braking system request: Off
Actuators test
Controls
Left front inlet solenoid valve
Right front inlet solenoid valve
Right rear inlet solenoid valve
Left rear inlet solenoid valve
Left front outlet solenoid valve
Right front outet solenoid valve
Left rear outlet solenoid valve
Right rear outlet solenoid valve
Master cylinder isolation valve 1
Master cylinder isolation valve 2
Electromagnetic switchover valve 1
Electromagnetic switchover valve 2
Pump motor
Utility
Controls
Hardware reset