Car, SHUANGHUAN, SCEO, EQ491 - Delphi 1 (ECM)
EQ491 - Delphi 1 (ECM) - 0
DTC
P1210: Unknown DTC
Controls
Clear DTC
Data stream
Barometric pressure sensor: 62.5 kPa
Calculated catalytic converter temperature: 459.0 °C
Intake air temperature sensor: 1.66 V
Engine coolant temperature sensor: 1.70 V
Target idle speed actuator: 54 steps
Throttle position sensor: 2.56 V
Ignition angle: 6 °
Engine speed: 1725.0 rpm
Injection time bank 1: 20.4 ms
Idle speed actuator: 70 steps
Throttle position sensor: 14.8 %
Evaporative emission (EVAP) system, canister purge valve: 13.6 %
MAP sensor: 41.4 kPa
Time since engine start: 9544 sec
O2 sensor 1, bank 1: 0.159 V
Battery voltage: 7.00 V
Engine coolant temperature sensor: 0.0 °C
Intake air temperature sensor: 0.0 °C
Target engine speed: 399.9 rpm
Air/Fuel ratio: 12.8 :1
Power enrichment: No
O2 sensor loop control bank 1: Open Loop
Deceleration fuel cut-off: Off
O2 sensor 1, bank 1: Lean
Acceleration fuel enrichment: Off
Block learn: Not active
Clear flood mode: Not active
A/C run: No
A/C temperature sensor: Not active
Diagnostic request: Off
A/C request: Off
Fuel pump: Off
A/C cut-off due to throttle wide open: Not active
A/C clutch: Off
Torque converter slip: Disable
Knocking protection: Enable
A/C cut-off due to full load (no delay): Not active
Immobilizer
Immobilizer status: Not active
Wrong transponder key: No
Actuators test
Controls
Check engine telltale
Evaporative emission (EVAP) system, canister purge valve
Fuel pump relay
A/C relay
Idle rpm control
Air/Fuel ratio
Idle speed actuator