Car, HAFEI, SIMBO (SAIMA), HFJ7160 - UAES M7.8 (ECM)

HFJ7160 - UAES M7.8 (ECM) - 0

Identification

Hardware number: R123456789

Software number: D

DTC

P0109: Unknown DTC

P0301: Misfire detected, cylinder 1

P0302: Misfire detected, cylinder 2

P0444: Evaporative emission (EVAP) system canister purge valve - circuit low voltage

Controls

Clear DTC

Data stream

Retard ignition knock control at cylinder 1: 0.00 Grad kw

Retard ignition knock control at cylinder 2: 0.00 Grad kw

Retard ignition knock control at cylinder 3: 0.00 Grad kw

Retard ignition knock control at cylinder 4: 0.00 Grad kw

A/C evaporator temperature sensor: -48.00 °C

A/C evaporator A/D value: 0.00 V

Absolute intake manifold pressure: 0 hPa

Intake manifold pressure sensor, calculated value: 0.00 V

Target mass air flow: 0 kg/h

Average fuel injection pulse width: 0.00 ms

Short term fuel trim O2 sensor 1, bank 1: 0.00

Long term fuel trim O2 sensor 2, bank 1: 0.00

O2 sensor 1, bank 1: 0.00 V

O2 sensor 2, bank 1: 0.00 V

Battery voltage: 0.00 V

Relative fuel injection quantity of canister control: 0.00 %

Canister purge duty cycle: 0.00

Charging time: 0.00 ms

Circumstance temperature: -40 °C

Criple time: 0 min

Number of DTC: 0

Engine coolant temperature: -40 °C

Engine coolant temperature sensor: 0.00 V

Relative engine load: 0.00 %

Engine speed: 0 rpm

Cooling fan PWM: 0.00 %

Fuel flow: 0.00 L/h

Intake air temperature: -40 °C

Intake air temperature sensor: 0.00 V

Idle torque adaptation: 0.00 %

Idle speed control target torque correction: 0.00 %

Knock sensor signal (B1): 0.00 V

Knock sensor signal (B2): 0.00 V

Odometer: 1 m/s²

Engine running time: 1 min

Target stepper motor position: 0 steps

Target idle speed with compensation: 0 rpm

Target idle speed without compensation: 0 rpm

Throttle angle ADC signal: 0.00 V

Calculated throttle position: 0.00 %

Throttle motor PWM control signal: 0.00 %

Vehicle speed: 0 km/h

Vehicle lateral acceleration: 0.00 m/s²

A/C system refrigerant monitoring:

A/C compressor torque request: --

Engine dynamic working condition: Activation of accelerator pedal position sensor; ; ;

Engine at idle:

Engine status: 3528 Impulses/Km or 5676 Impulses/Mi

Check engine telltale:

O2 sensor monitoring:

Programming status:

Actuators test

Controls

Check engine telltale

Evaporative emission (EVAP) system, canister purge valve

A/C relay

Cooling fan low speed

Cooling fan high speed

Disable fuel injection 1

Disable fuel injection 2

Disable fuel injection 3

Disable fuel injection 4