Bil, SSANGYONG, Stavic-Rodius (A120), D20DTR (ECM)

D20DTR (ECM) - 0

Identifikation

Stel nr.: KPTA0A1SSBP025404

Hardware number: 28076680

Hardware version nummer: 28283968

Softwareversion: UCA34E154_D20DTR_C200AT6_149ps

Calibration ID 2: --

Fejlkoder

P0683 [0]: Ingen kommunikation med gløderørsstyremodul

U3FFF [3]: GCU absent

P1124 [0]: Accelerator pedal position sensor 1/A/single - stuck

Controls

Clear DTC

Levende Data

Brændstoftemperaturføler: 62 °C

Ladetryk: 0.930 bar

Speeder pedal positions føler N1: 0.000 %

Speeder pedal position N2: 0.000 %

Accelerator pedal position sensor: 0.000 %

Tryk i brændstoffordelerrør: 250 bar

Barometrisk tryk føler: 0.980 bar

Kølemiddeltemperatur: 81 °C

Air temperature: 46 °C

Batteri spænding: 14.30 V

Luft masse måler: 290 mg/slag

Køretøjs hastighed : 0 km/h

Gear position: P/N

Knock sensor 1: 280

Knock sensor 2: 280

A/C head pressure input: 7.4 bar

EGR-ventil, position: 7.999 %

Throttle valve position: 14.896 %

VGT position: -20.000 %

Swirl flap - position: 79.918 %

Boost temperature: 52 °C

O2 sensor 1, bank 1 heater: Sluk

Lambda sonde / O2 sensor 1, bank 1: 10.000

Fuel quantity: 0.0 mg/slag

Motor Hastighed: 0 Omdr.

Motordrejningsmoment: 32 N·m

Ladetrykføler: 1.180 bar

Rail pressure (MAP): 250 bar

VGT duty cycle: 31.752 %

EGR valve duty cycle: 14 %

Electronic throttle control (ETC) motor duty: -20 %

Swirl flap - duty cycle: 22.344 %

Cooling fan PWM: 0.000 %

Engine start enable: Aktiveret

Main fuel advance (MAP): -0.7 °

Main fuel quantity (MAP): 3.0 mg/slag

Inlet valve duty (MAP): 830 mA

Target idle speed: 768 Omdr.

Engine state: Kører

Clutch switch: Indkoblet

Brake light switch: Sluk

Brake safety switch: Sluk

Brake switch: Sluk

A/C-kontakt: Sluk

A/C control: Sluk

Power relay: Tænd

Glow plug: Sluk

PTC relay 1: Sluk

PTC relay 2: Sluk

Cruise control "Off" switch: Sluk

Cruise control "Safety" switch: Tænd

Cruise control "Accelerate" switch: Sluk

Cruise control "Decelerate" switch: Sluk

Cruise control "Resume" switch: Sluk

Blower switch: Sluk

Glow plug lamp: Sluk

Check motor fejllampe: Sluk

Water in fuel telltale: Sluk

Udgangs test

Controls

Throttle valve actuator

EGR-ventil

Glow plug

Inlet valve

VGT valve

Cooling fan high speed

Check motor fejllampe

Glow plug lamp

Immobilizer telltale

A/C relay

PTC relay 2

PTC relay 1

Water in fuel telltale

Swirl flap

Bypassventil til EGR-køler

indsprøjtnings dyser

Muligheder

Controls

Rediger stel nr.

Injectors replacement

Electronic throttle learning

IMV learning and HP pump initialization

Reset EGR adaptation

Reset swirl flap adaptation

Reset VGT adaptation

Reset O2 sensor adaptation

Fuel rail pressure sensor replacement

Fuel rail pressure test

IMV test

Hydraulic test

DPF regeneration (while driving)

DPF replacement

Konfiguration

Controls

Redigere konfiguration