Bil, SSANGYONG, Rexton II (Y250), D20DT C3I (ECM)

D20DT C3I (ECM) - 0

Identifikation

Stel nr.: KP-S0A1KSAP138758

Software nummer: NCD12

Softwareversion: A01

Programming date: 2010-06-19

ECU serial number: DYPJ32199v0080

Fejlkoder

P0107: Turbocharger boost pressure sensor - circuit open

Controls

Clear DTC

Levende Data

Brændstoftemperaturføler: 71 °C

Ladetryk: 1.001 bar

Speeder pedal positions føler N1: 0.0 %

Speeder pedal position N2: 0.0 %

Accelerator pedal position sensor: 0.0 %

Tryk i brændstoffordelerrør: 0 bar

Barometrisk tryk føler: 1.001 bar

Kølemiddeltemperatur: 77 °C

Air temperature: 58 °C

Batteri spænding: 12.20 V

Luft masse måler: 590.0 mg/slag

Køretøjs hastighed : 0 km/h

Gearforhold: P/N

Knock sensor 1: 0

Knock sensor 2: 0

Kilometer tæller: 80336.000 km

A/C head pressure input: 6.1 bar

EGR-ventil, position: 0.0 %

Gasspjældsposition: 99.9 %

VGT position: 0.0 %

Fuel quantity: 0.0 mg/slag

Motor Hastighed: 0 Omdr.

Motordrejningsmoment: -4 N·m

Turbocharger boost pressure (MAP): 1.027 bar

Rail pressure (MAP): 200 bar

VGT duty cycle: 9.8 %

EGR valve duty cycle: 0.0 %

EGR demand: 510.0 mg/slag

Fan 1 output (Low): 0.0 %

Fan 1 output (High): 0.0 %

Main fuel advance (MAP): -1.0 °

Main fuel quantity (MAP): 0.0 mg/slag

Inlet valve (MAP): 60 mA

Target idle speed: 768 Omdr.

Engine state: Sluk

Engine start enable: Ja

Injector 1 MDP adaption count: 431

Injector 2 MDP adaption count: 431

Injector 3 MDP adaption count: 430

Injector 4 MDP adaption count: 430

Clutch switch: Tænd

Brake light switch: Sluk

Brake safety switch: Sluk

Brake switch: Sluk

A/C-kontakt: Sluk

Accelerator pedal position sensor 1 supply voltage: 5.00 V

Accelerator pedal position sensor 2 supply voltage: 5.00 V

A/C control: Sluk

Power relay: Tænd

Glow plug: Sluk

PTC relay 1: Sluk

PTC relay 2: Sluk

Cruise control "Off" switch: Sluk

Cruise control "Safety" switch: Sluk

Cruise control "Accelerate" switch: Sluk

Cruise control "Decelerate" switch: Sluk

Cruise control "Resume" switch: Sluk

Blower switch: Sluk

Glow plug lamp: Sluk

Check motor fejllampe: Sluk

Water in fuel filter: Sluk

Udgangs test

Controls

EGR-ventil

Electronic throttle control (ETC)

Glow plug

Inlet valve

VGT valve

Cooling fan low speed

Cooling fan high speed

Power supply relay

Check motor fejllampe

Glow plug lamp

Immobilizer telltale

A/C relay

PTC relay 2

PTC relay 1

Water in fuel telltale

indsprøjtnings dyser

Muligheder

Controls

Fuel leakage check

Injectors replacement

Fuel correction table

Reset EGR adaptation

Reset throttle position sensor learn

Reset rail pressure

Rediger stel nr.

Konfiguration

Controls

Redigere konfiguration