Bil, RENAULT, TWINGO II, D7F - Petrol (INJ)

Electronic version: 32 35 37 35 52

Program number: 34 D3

Softwareversion: 45 00

Kalibreringsnummer: 43 80

MPR reference: 34 30 33 34 52

Diagnose version: 50

Supplier: 153

Stel nr.: X7LHSRDVN51262429

DF080 [CO]: Camshaft dephaser - circuit open

Clear DTC

Engine oil dilution ratio: -- km

Number of engine rotation: --

Driving distance since last service: -- km

Idle speed reference: 0 Omdr.

Korrektion af tomgangshastighed: 0 Omdr.

Køretøjs hastighed : 0 km/h

Ladetryk: 103 mbar

Ignition advance angle: -24 °CRK

Knock correction: 0 °CRK

Turbocharging solenoid valve duty cycle setting: 0 %

Motor kølevæske temperatur føler: -- °C

Alcohol fuel adaptive correction: -- %

Alcohol level est. in reservoir: -- %

Intake air temperature sensor: -40 °C

MAP føler: 103 mbar

Barometrisk tryk føler: 0 mbar

Motor Hastighed: 0 Omdr.

Controlled coolant thermostat duty cycle: -- %

Computer + after ignition: Missing

Pedal no load and throttle closed: Nej

Engine revolutions since last oil service: --

Brake pedal: Udløst

Actuator relay control: Inaktiv

Cooling fan high speed relay: Inaktiv

Cooling fan low speed relay: Inaktiv

Kommando til brændstofpumperelæ: Inaktiv

Canister purge control: Inaktiv

O2 sensor 1, bank 1 heater: Inaktiv

O2 sensor / Lambda sonde 2, bank 1 Varme element: Inaktiv

Gaspedalposition: -- %

Speeder pedal positions føler N1: -- V

Speeder pedal position N2: -- V

No load position programming value: -- %

Mass or volume air flow sensor estimated value: -- kg/h

Electronic throttle control (ETC) throttle position 1 upper stop: -- V

Electronic throttle control (ETC) throttle position 2 upper stop: -- V

Electronic throttle control (ETC) throttle position 1 lower stop: -- V

Electronic throttle control (ETC) throttle position 2 lower stop: -- V

Throttle lower limit after offset applic.: -- %

Gasspjælds positions føler: -- %

Electronic throttle control (ETC) position corrected value : -- %

Electronic throttle control (ETC) corrected position setting: -- %

Speeder pedal positions føler N1: -- %

Speeder pedal position N2: -- %

Gasspjældpositionsføler 1: -- %

Gasspjældpositionsføler 2: -- %

Throttle actuator at lower mechanical stop: -- %

Electronic throttle control (ETC) high stop programmed value: -- %

Gasspjældpositionsføler 1: -- V

Gasspjældpositionsføler 2: -- V

Richness autoadaptive offset: --

Richness autoadaptive gain: --

Theoretical idle regulation RCO: -- %

Richness correction: -- %

Inlet camshaft dephaser position reference value: -- °

Injection time: -- ms

Canister bleed solenoid valve RCO: -- %

Idle regulation programming value: -- %

Average knock signal: --

Lambda sonde / O2 sensor 1, bank 1: -- V

O2 sensor 2, bank 1 average value: -- ms

Lambda sonde / O2 sensor 2, bank 1: -- V

Motordrejningsmoment: -- N·m

Distance since check engine telltale on (OBDII): -- km

Misfire cylinder 1: --

Misfire cylinder 2: --

Misfire cylinder 3: --

Misfire cylinder 4: --

Flywheel target programming: --

Cylinder 1 recognition: --

Double richness loop : --

Idle rpm control: --

Programming throttle limits: --

Richness regulation: --

Flywheel signal: --

Operating mode: --

Cooling fan high speed relay: --

Cooling fan low speed relay: --

Acceleration pedal detection blocked: --

Instantaneous fuel consumption: -- L/h

Advance after anti-pinking correction: -- °CRK

Immobilizer code programmed: Nej

Startspærre: Inaktiv

Impact detected: Inaktiv

Refrigerant pressure: --

Refrigerant pressure: -- bar

A/C authorisation: --

A/C request: --

Accelerated idle request: --

Air conditioner: --

Cooling fan high speed request: --

Cooling fan low speed request: --

Power absorbed by the AC compressor: -- W

A/C command: --

Starting: --

Motor: --

Brake pedal switch 2: --

Cruise control setting: -- km/h

Brake pedal switch 1: --

A/C relay

Cooling fan low speed

Cooling fan high speed

Controlled coolant thermostat

Camshaft shifter: On/Off control

Camshaft dephaser normal control

Brændstofpumperelæ

Electronic throttle control (ETC)

Evaporative emission (EVAP) system, canister purge valve

O2 sensor 1, bank 1 heating

O2 sensor 2, bank 1 heating

V013 Injector control lock

V008 Injector control unlock

V010 Rediger stel nr.

R005 Programmed values