Car, AUDI, A1 2011-, 2017 (H), Saloon, 5-door (Sportback), CVNA 1.4l TFSI , 110 kW, 01 - Engine (01 MOT)
Engine - 01 - Engine (01 MOT) - 0
Identification
Identifier: 038906012J
System: 3.0L V6/5V 0001
Software coding: 26752
Workshop code: 472
Extra data 1: WAUZZZ4B23N045457 AUZ7Z0B2222532
DTC
00771 (0771): Fuel level sensor (G)
01039 (1039): Coolant temperature sensor (G2)
01128 (1128): Immobilizer reader coil (D2)
01176 (1176): Key
01179 (1179): Incorrect key programming
Controls
Clear DTC
Data stream
Engine speed: 0 rpm
Injection quantity: 46.0 °C
Modulating piston movement sender voltage: 0.0 %
Engine coolant temperature sensor: 0.0 %
Accelerator pedal position sensor 1: 100.0 %
A/C compressor: Off ms
Idle speed position switch: Open ms
Idle speed increase: Off ms
Target mass air flow: 0.0 g/sec
Mass air flow (actual): 5.9 %
EGR valve duty cycle: 0.0 °
Target injection timing: 11.900 V
Actual injection timing: 46.0 °C
Injection timing valve duty cycle: 32.0 °C
Fuel injection quantity (start): 100.0 %
Vehicle speed sensor: 0 rpm
Brake light switch: Open %
Brake pedal switch: Closed %
Clutch pedal switch: Open %
Cruise control: 32.0 °C
Cruise control: -3.1 %
Fuel temperature sensor:
Intake manifold temperature sensor:
Injection quantity requested (accelerator pedal): Pump off
Injection quantity limitation via revolutions (torque limitation): 310 mbar
Injection quantity limitation due to air mass flow (smoke prevention): Test off
Injection quantity (cruise control active):
Injection quantity limitation during gear change:
Barometric pressure sensor: 100.0 %
Target charge air pressure: 46.0 °C
Charge air pressure: 32.0 °C
Charge air pressure regulation valve duty cycle: 0.0 °
Glow status:
Pre-glow period:
Battery voltage:
Fuel quantity variation between cylinder 1 and average injection quantity:
Fuel quantity variation between cylinder 2 and average injection quantity:
Fuel quantity variation between cylinder 3 and average injection quantity:
Fuel quantity variation between cylinder 4 and average injection quantity:
Fuel consumption: 0
Generator load: 0
Aux heating shut-off: coolant temperature above 80°C: No
Aux heating shut-off: generator defective: No
Aux heating shut-off: battery voltage too low: No
Aux heating shut-off: engine speed too low: No
Aux heating shut-off: starting delayed: No
Aux heating shut-off: system malfunction (G62 or G72 faulty): No
Aux heating: low heat output relay on: No
Aux heating: high heat output relay on: No
Speed limitation: Not active rpm
Speed limitation: Present rpm
Max. speed limit: 0.0 %
Modulating piston movement sender lower stop:
Modulating piston movement sender upper stop:
Checksum: 1.872 V
Communication with TCM: Transmission 1
Communication with ABS: ABS 1
Communication with IC instrument cluster: Instriments 1
Communication with airbag:
Channel 0
Engine speed: 1
Actual injection timing: 200
Accelerator pedal position sensor: 0
Injection quantity: 1
MAP sensor: 200
Barometric pressure sensor: 0
Engine coolant temperature sensor: 33
Intake manifold temperature sensor: 133
Fuel temperature sensor: 0
Mass air flow sensor: 33
Readiness test
Malfunction indicator lamp on:
DTC detected: 0
Misfire detection monitoring:
Fuel system monitoring:
Complete system monitoring:
O2 sensor monitoring: Not present
O2 sensor heater monitoring: Not present
EGR system monitoring: Not present
Base settings
Controls
Dynamic start of injection adjustment
EGR test
Checking injection timing control range
Configuration
Controls
Configuration
Utility
Controls
Injection quantity
Adjust idle speed
Exhaust gas recirculation
Start injection time
Starting injection quantity adjustment
Pre-glow period
Maximum speed limit
Immobilizer (vehicle data learning)
Immobilizer status
Cruise control
Actuators test
Controls
Actuators test
Manual mode
Controls
Data stream
Basic setting
Adaptation
Login
Configuration