Bil, TAGAZ, VEGA (C100), GA16 - Motor (ECM)

Boot software number: KR77185271--

Software nummer: KR77185173--

Calibration version: TA6MBM630000

Stel nr.:

P0122: Throttle position sensor (TPS) signal 1 - circuit open or short ground

P0031: O2 sensor 1, bank 1 heater - circuit short to ground

Clear DTC

Gasspjælds positions føler: 0.391 V

MAP føler: 319.965 V

Motor kølevæske temperatur føler: 75.0 °C

Intake air temperature sensor: 60.0 °C

Gasspjælds positions føler: 0.0 °

Batteri spænding: 12.65 V

Køretøjets hastighed sensor: 0 km/h

Motor Hastighed: 0 Omdr.

Barometrisk tryk føler: 100.238 kPa

MAP føler: 100.238 kPa

Luft masse måler: 0.0 mg/slag

Injection time (pilot): 0.0 ms

Manual gear position: P/N range

Gear inserted (for Autom. gear): P/N range

Tank luft ventil: 0.0 %

Fuel tank level: 23.8 %

A/C pressure: 717.4 kPa

Tændings vinkel: 24.2 °

Lambda sonde / O2 sensor 1, bank 1: 0.411 V

Lambda sonde / O2 sensor 2, bank 1: 0.411 V

O2 sensor 1, bank 1 heater: 2.292 %

O2 sensor / Lambda sonde 2, bank 1 Varme element: 2.292 %

Statspærrestatus:

ECU status: Learnt

Fuel pump relay: Sluk

Idle speed: Sluk

Part load status: Sluk

Throttle wide open position: Sluk

Closed throttle position switch: Sluk

Engine full load: Sluk

Vehicle transmission type: M/T

Startspærre: Tilstede

Fuel tank level: 31.618 %

Wheel speed sensor (Hall): 2 km/h

Trip distance: 0 km

P/N switch: Parkering/frigear

A/C input status: Sluk

Motor status: Tænding til

Select solenoid duty ration: 37.0 %

Target idle speed: 0 Omdr.

Ignition angle cylinder 1: 4.9 °

Ignition angle cylinder 3: 4.9 °

Ignition angle cylinder 4: 4.9 °

A/C compressor relay:

Ignition angle cylinder 2: 4.9 °

Time injection correction coefficient: 0.0 %

Injection time cylinder 1: 0.0 ms

Injection time cylinder 3: 0.0 ms

Injection time cylinder 4: 0.0 ms

Injection time cylinder 2: 0.0 ms

Evaporator control: Sluk

Knocking detected: Sluk

Close loop control: Sluk

Misfire cylinder 2: 0

Misfire cylinder 4: 0

Misfire cylinder 1: 0

Misfire cylinder 3: 0

ABS:

Fuel pump

Power supply relay

indsprøjtnings dyser

A/C relay

Cooling fan high speed

Cooling fan low speed

Check motor fejllampe