Car, PEUGEOT, 206, 8HX - EDC16C3

8HX - EDC16C3 - 0

Identification

PSA reference: 96 47 78 55 80

ECU manufacturer: Valeo

Additional number: 96 44 09 83 80

Diagnostic version: FF

Calibration version: FF FF

Software version: B0 03

Emission: Not defined

ECU production date: --

Software reference: 00 00 00

DTC

P0704: Clutch switch signal no signal or signal not range/performance

Controls

Clear DTC

Data stream

Inlet air temperature at manifold: 0.0 °C

Barometric pressure sensor: 0.000 bar

Turbo pressure: 0.000 bar

Vehicle speed sensor: 0 km/h

Clutch pedal: Pressed

Gear engaged: Neutral

Fuel temperature sensor: -40.0 °C

Engine coolant temperature sensor: 202.0 °C

Intake air temperature sensor: 87.5 °C

Engine speed: 7870.7 rpm

Battery voltage: 25.60 V

Camshaft and crankshaft synchronization:

Fuel flow regulator: 33.3 %

Diesel output delivered by the pump reference value: 23690.2 mm³/s

Target mass air flow: 960.8 mg/impulse

Brake pedal: Pressed

Pre-post heating relay: 175

Fuel pressure measured: 0.0 bar

Accelerator pedal position sensor: 0.0 %

Mass air flow sensor: 0.0 mg/impulse

Mass air flow sensor: 0.0 mg/impulse

Injectors 1/4: 0

Injectors 2/3: 0

Injector 1 correction value: -6.0 mg/impulse

Injector 3 correction value: -6.0 mg/impulse

Injector 4 correction value: -6.0 mg/impulse

Injector 2 correction value: -6.0 mg/impulse

Reference fuel pressure: 0.0 bar

EGR throttle electrovalve open cycle ratio: 0.0 %

EGR solenoid valve: 0.0 %

Immobilizer

Locking of the ECU: Locked

Immobilizer status: Matched ECU

Problem detected when transmitting the unlock code: The programming status of the engine immobiliser cannot be read

Actuators test

Controls

Cooling fan high speed

Cooling fan low speed

Additional heating relay

Preheating relay

EGR valve

Diesel pressure regulation

Utility

Controls

Injectors replacement