Car, PEUGEOT, 607R, CAN, UHZ - SIEMENS SID 201
UHZ - SIEMENS SID 201 - 0
Identification
PSA reference: 96 48 23 76 80
ECU - manufacturer: Siemens
Additional number: 96 48 23 76 80
Software version: 10 13
Software reference: 63 11 37
DTC
P0532: Air conditioner refrigerant pressure sensor - circuit open or short to ground
P0104: Rear mass or volume air flow (MAF) signal 1 - flow too low
P0490: Exhaust gas recirculation (EGR) valve position 1 (rear) solenoid - locked
P010F: Air flowmeter signals - consistency between the 2 air flowmeters
Controls
Clear DTC
Data stream
Engine speed: 0.0 rpm
Battery voltage: 11.66 V
Injector: 60.05 V
Fuel injection - time (main): 0.0 ms
Intake air temperature sensor: 26 °C
Engine coolant temperature sensor: 54 °C
Barometric pressure sensor: 1001.6 mbar
Turbo pressure: 980.3 mbar
Engine status: Engine off
Supply voltage: 4.96 V
Supply voltage: 4.96 V
Accelerator pedal position sensor 1: 0.39 V
Accelerator pedal position sensor 2: 0.20 V
Gear transmission ratio: Neutral
A/C compressor - current consumption: 0 W
Catalytic converter - exhaust gas temperature: 100.4 °C
Water in fuel sensor: 4.86 V
Generator charge information: 0.0 %
Fuel injection - advance: 0.0 °
Power relay: Activated
Vehicle speed sensor: 0 km/h
Cooling fan relay: Not activated
Cooling fan - speed: 0.0 %
Refrigerant circuit pressure: 4.0 bar
Fuel temperature sensor: 26 °C
Accelerator pedal position sensor: 0.0 %
Brake pedal switch: Pressed
Brake pedal - redundant: Pressed
Pre-post heating relay: Released
A/C cut-off request: Yes
Fuel pressure - measured: 0.0 bar
Injected - output: 0 mg/impulse
Pre-injection - advance 1: 0.0 °
Fuel injection - advance: 0.0 °
Injector 1 - correction value: 19.5 %
Injector 4 - correction value: 135.0 %
Injector 2 - correction value: 135.0 %
Injector 5 - correction value: 39.0 %
Injector 3 - correction value: 135.8 %
Injector 6 - correction value: 199.0 %
Pre-injection - advance 2: 0.0 °
Pre-injection - flow 1: 0.0 mg/strk
Reference fuel pressure: 0.0 bar
Target mass air flow: 0.0 mg/impulse
Mass air flow sensor: 0.0 mg/impulse
Camshaft and crankshaft synchronization:
Pre-injection - flow 2: 0 mg/strk
DPF information
Engine coolant temperature sensor: 54 °C
Engine speed: 192.0 rpm
Vehicle speed sensor: 17 km/h
Diesel particulate filter (DPF) - soot mass: 97.3 %
Diesel particulate filter (DPF) - regeneration status: No
Catalytic converter - exhaust gas temperature: 513.8 °C
Diesel Particulate filter (DPF) - differential pressure: 2727.7 mbar
Intake air temperature at the air flow sensor: 50 °C
Power consuming equipment activation request:
Exhaust air flow density: 1092250.0 L/h
EGR throttle - position setting: 30.6 %
Pre-injection - flow 1: 177.8 mg/strk
Pre-injection - flow 2: 255 mg/strk
Type driving: Regeneration impossible
Diesel Particulate filter (DPF) - distance since last regeneration: 3289.6 km
Turbo pressure: 0.213 bar
Percentage of driving during previous hour in town - severe: 136.6 %
Percentage of driving during previous hour in town - average: 7.8 %
Percentage of driving during previous hour in extra urban - slow: 136.6 %
Percentage of driving during previous hour in extra urban - fast: 199.0 %
Percentage of driving during previous hour on motorway: 136.6 %
Percentage of driving done in town - severe: 135.0 %
Percentage of driving done in town - average: 135.0 %
Percentage of driving done in extra urban - slow: 199.0 %
Percentage of driving done in extra urban - fast: 7.8 %
Percentage of driving done on motorway: 7.8 %
Diesel Particulate filter (DPF) - distance since last changed: 299.1 km
Diesel Particulate filter (DPF) - clogging degree telltale: 141.2 %
Diesel Particulate filter (DPF) - distance remaining until replacement (scheduled maintenance): 300000.0 km
Average distance for the last 5 regenerations: 4999.5 km
Diesel Particulate filter (DPF) - status:
Diesel particulate filter (DPF) - regeneration possibility: Impossible
Immobilizer
Locking of the ECU: Locked
Immobilizer - status: Programmed 2 times
Problem detected when transmitting the unlock code: The programming status of the engine immobiliser cannot be read
Actuators test
Controls
Electronic throttle control (ETC)
Injector 1
Injector 2
Injector 3
Injector 4
Evaporative emission (EVAP) system, canister purge valve
Cooling fan high speed
Cooling fan low speed
Power supply relay
Additional heating relay
Utility
Controls
Diesel particulate filter static regeneration