Car, PEUGEOT, 407, 3FY - MM6LPB CAN

PSA reference: 96 52 55 20 80

ECU manufacturer: Magneti Marelli

Additional number: 96 59 58 07 80

Software version: 02 00

Software reference: 64 94 74

P1676: Controlled generator control

Clear DTC

Engine speed: 0.0 rpm

Battery voltage: 12.20 V

Injection time bank 1: 0.0 ms

Deceleration fuel cut-off: No

Throttle position sensor: Idle

Throttle position sensor: 5.2 °

Throttle position sensor: 0.784 V

Engine coolant temperature sensor: 10.0 °C

MAP sensor: 982.8 mbar

Ignition angle: -12.2 °

Coil 1,4 dwell time: 1.9 ms

Ignition coil 3 dwell time: 1.9 ms

Coil 2,3 dwell time: 1.9 %

Ignition coil 4 dwell time: 1.9 ms

O2 sensor 1, bank 1: Lean

O2 sensor 2, bank 1: Lean

O2 sensor 1, bank 1: 0.000 V

O2 sensor 2, bank 1: 0.000 V

Richness regulation: Open Loop

Intake air temperature sensor: 10.2 °C

Evaporative emission (EVAP) system, canister purge valve: Inactive

Canister electrovalve duty cycle: 0.0 %

A/C relay: No

A/C request: No

Oil temperature: 3 °C

Refrigerant circuit pressure: 2.2 bar

Accelerator pedal position sensor: 0.0 %

Accelerator pedal point of resistance sensor: Not activated

Engine load: 0.0 N·m

Power supply relay: Inactive

Vehicle speed sensor: 0 km/h

Gear transmission ratio: N

Cooling fan relay: Inactive

Fan unit speed setting: 0.0 %

ECU status: Main

EGR solenoid valve programming status: Not learned

Throttle valve learning status: Learned

Camshaft dephasing: 27.2 °

Camshaft dephaser solenoid valve: Active

Locking of the ECU: Locked

Immobilizer status: After-sales status

Problem detected when transmitting the unlock code: No problem

Electronic throttle control (ETC)

Injector 1

Injector 2

Injector 3

Injector 4

Fuel pump relay

Evaporative emission (EVAP) system, canister purge valve

Cooling fan high speed

Cooling fan low speed

VVT solenoid valve

Ignition coil 1

Ignition coil 2

Ignition coil 3

Ignition coil 4

ECU learn reset