Car, PEUGEOT, 307, VAN, KFU - MM6LP
KFU - MM6LP - 0
Identification
PSA reference: 96 47 49 81 80
ECU manufacturer: Magneti Marelli
Additional number: 96 47 49 81 80
Diagnostic version: 0D
Calibration version: FF FF
Software version: 09 02
Emission: US 83 Brazil, Mercosur without EOBD on Partner only
ECU production date: --
Software reference: 61 77 18
DTC
P0012: Variable valve gear solenoid valve command upper limits
Controls
Clear DTC
Data stream
Engine speed: 0.0 rpm
Battery voltage: 12.60 V
Injection time bank 1: 0.0 ms
Deceleration fuel cut-off: No
Throttle position sensor: Idle
Throttle position sensor: 43.7 °
Throttle position sensor: 0.706 V
Engine coolant temperature sensor: -50.0 °C
Intake air temperature sensor: 90.0 °C
MAP sensor: 998.4 mbar
Ignition angle: 49.4 °
Ignition coil 1 dwell time: 28.6 ms
Ignition coil 3 dwell time: 29.8 ms
Ignition coil 4 dwell time: 29.8 ms
Ignition coil 2 dwell time: 29.8 ms
O2 sensor 1, bank 1: Lean
O2 sensor 2, bank 1: Rich
O2 sensor 1, bank 1: 1.658 V
O2 sensor 2, bank 1: 4.973 V
Richness regulation: Closed Loop
Engine coolant temperature sensor: 26.0 °C
Intake air temperature sensor: 3.0 °C
Evaporative emission (EVAP) system, canister purge valve: Inactive
Evaporative emission (EVAP) system, canister purge valve: 0.0 %
A/C relay:
A/C request:
Engine oil temperature sensor: 215.0 °C
Refrigerant pressure: 1.1 bar
Engine load: -100.0 N·m
Power supply relay: Active
Vehicle speed sensor: 1 km/h
Gear transmission ratio:
Cooling fan relay: Active
Camshaft position: 72.4 °
CVVT status: Active
Immobilizer
Locking of the ECU: Locked
Immobilizer status: Matched ECU
Problem detected when transmitting the unlock code: No problem
Actuators test
Controls
Electronic throttle control (ETC)
Injector 1
Injector 2
Injector 3
Injector 4
Fuel pump relay
Evaporative emission (EVAP) system, canister purge valve
O2 sensor 1, bank 1 heater
O2 sensor 2, bank 1 heater
Cooling fan high speed
Cooling fan low speed
Ignition coil 1
Ignition coil 2
Ignition coil 3
Ignition coil 4
Utility
Controls
ECU learn reset