Car, OPEL, Corsa D, 2012, MTA (Magneti Marelli)

Transaxle - MTA (Magneti Marelli) - 0

Identification

VIN no: W0L0ZCF6971104579

System identification: MAREL0200

System: MTAM20 Z13DTH

Hardware key number: Z14XESDL68

Identifier: 04 01

ECU diagnostic address: 18

Software version number: GA30AYBF

Part number: 55185790

Hardware number: 55563281

Alpha code: M1

DTC

P1735 [0]: Gearbox parameters not learned

P1707 [0]: Clutch adaption

Controls

Clear DTC

Data stream

Shift position: 3534 mm

Select position actual: 14 °

Shift solenoid valve 2/B: 804 mA

Shift solenoid valve 1/A: 1284 mA

Actual clutch position: 49.01 mm

Target clutch position: 319.46 mm

Clutch solenoid current: 1474 mA

A/T input speed: 65282 rpm

Accelerator pedal position sensor 1: 0 %

Engine coolant temperature sensor: 24 °C

Engine speed: 65315 rpm

Actual torque signal: -5632 N·m

Outside air temperature: 7 °C

System voltage: 6405 V

Vehicle speed sensor: 255 km/h

Oil pressure: 1 bar

Selector lever position: Not active

Winter mode switch: Not active

Selected mode:

Gear position (current):

Crank request: Yes

Brake pedal switch: Open

Parking brake status: Active

Sport mode switch: Not active

Kickdown switch: Off

Select solenoid valve: Active

Pump motor relay: Not active

Crank enable: Disable

Clutch closed position: 1437 mm

Clutch engagement: 1 mm

Clutch temperature: -32000 °C

Oil temperature: 234 °C

Actuators test

Controls

Pump relay

Clutch test

Select solenoid valve test

Shift solenoid valve test

Utility

Controls

Edit VIN

Empty accumulator

Hydraulic clutch bleed

Recalibrate ECU

ECU replaced

МТA with ECU replaced

MTA with ECU disassembled

Shift Module with ECU replaced

Shift module with ECU disassembled

Clutch replaced

Clutch module replaced

Clutch position sensor replaced

Clutch disassembled

Gearbox replaced (with MTA and ECU)

Gearbox replaced (without MTA and ECU)

Gearbox disassembled (with MTA and ECU)

Shift and/or select sensor replaced

Values and/or pressure sensor replaced

Power unit replaced

Electric motor replaced

Configuration

Controls

Edit CAN configuration