Bil, OPEL, Corsa D, 2009, MTA (Magneti Marelli)
transakse - MTA (Magneti Marelli) - 0
Identifikation
Stel nr.: W0L0ZCF6971104579
Systemidentifikation: MAREL0200
System: MTAM20 Z13DTH
Hardware key number: Z14XESDL68
Identificere : 04 01
ECU diagnostic address: 18
Software version number: GA30AYBF
Dele nummer: 55185790
Hardware number: 55563281
Alpha code: M1
Fejlkoder
P1735 [0]: Gearbox parameters not learned
P1707 [0]: Clutch adaption
Controls
Clear DTC
Levende Data
Shift position: 3534 mm
Select position actual: 14 °
Shift solenoid valve 2/B: 804 mA
Shift solenoid valve 1/A: 1284 mA
Actual clutch position: 49.01 mm
Target clutch position: 319.46 mm
Clutch solenoid current: 1474 mA
A/T input speed: 65282 Omdr.
Speeder pedal positions føler N1: 0 %
Motor kølevæske temperatur føler: 24 °C
Motor Hastighed: 65315 Omdr.
Actual torque signal: -5632 N·m
Outside air temperature: 7 °C
Systemspænding: 6405 V
Køretøjets hastighed sensor: 255 km/h
Oil pressure: 1 bar
Gearvælgerstilling: Ikke aktiv
Winter mode switch: Ikke aktiv
Selected mode:
Gear position (current):
Drejeanmodning: Ja
Bremsepedalkontakt: Åben
Parking brake status: Aktiv
Sportsprogramkontakt: Ikke aktiv
Kickdown-kontakt: Sluk
Select solenoid valve: Aktiv
Pump motor relay: Ikke aktiv
Crank enable: Deaktiver
Kobling i lukket position: 1437 mm
Clutch engagement: 1 mm
Clutch temperature: -32000 °C
Oil temperature: 234 °C
Udgangs test
Controls
Pump relay
Clutch test
Select solenoid valve test
Shift solenoid valve test
Muligheder
Controls
Rediger stel nr.
Empty accumulator
Hydraulisk koblingsudluftning
Recalibrate ECU
ECU replaced
МТA with ECU replaced
MTA with ECU disassembled
Shift Module with ECU replaced
Shift module with ECU disassembled
Clutch replaced
Clutch module replaced
Clutch position sensor replaced
Clutch disassembled
Gearbox replaced (with MTA and ECU)
Gearbox replaced (without MTA and ECU)
Gearbox disassembled (with MTA and ECU)
Shift and/or select sensor replaced
Values and/or pressure sensor replaced
Power unit replaced
Electric motor replaced
Konfiguration
Controls
Edit CAN configuration