Car, OPEL, Corsa C, Combo C, 2012, Z14XE - Multec (H)

Z14XE - Multec (H) - 0

Identification

VIN no: W0L0XCF2523026411

Repair shop code or tester serial number:

Programming date: FF FF FF FF

Hardware number: DEL 0115351289

Part number alpha code: 09364469 EU

Software number: DNZY

Software version: 4

Existing ECU type approval no: D02001

System: Z16SE

Identifier: 15 A5

Vehicle manufacturer specific: P0802A06

DTC

P0340 [0]: Camshaft position sensor - incorrect signal

P0120 [8]: Throttle position sensor (TPS) 1/A-2/B correlation

P1550 [B]: Electronic throttle control (ETC) power management

P1550 [A]: Electronic throttle control (ETC) limited performance

Controls

Clear DTC

Data stream

Cooling fan relay 1: Off

Cooling fan relay 2: Off

Cooling fan relay 3: Off

Ignition status: Off

Power supply relay: Off

Engine oil pressure: Low pressure

Fuel pump relay: Off

Full load enrichment: Active

Throttle position sensor: Full load

Knock control (B1): On

Deceleration fuel cut-off: Active

O2 sensor 1, bank 1 loop control: Open

EGR valve: Off

Evaporative emission (EVAP) system, canister purge valve: Off

Air/Fuel ratio sensor 1, bank 1: Lean

O2 sensor 1, bank 1 heater: Off

Air/Fuel ratio sensor 2, bank 1: Lean

O2 sensor 2, bank 1 heater: Off

Accelerator pedal position at idle position: Not active

Idle speed offset: Not active

Check engine telltale: Off

Service vehicle soon telltale: On

Electronic throttle control (ETC) limp home mode:

A/C relay: Off

A/C information switch: Off

A/C cut-off mode:

P/N switch: R-D-3-2-1 12V

Neutral control: Present

Torque control: Off

Brake pedal switch 2: Off

Clutch pedal switch: Not active

Vehicle speed in cruise control range: Active

Cruise control tip switch: I+O (Set+Off)

Brake pedal switch 1: On

Cruise control: Off

Oil pressure 1: Low pressure

Oil pressure 2: Low pressure

Oil pressure switch: Not active

Battery voltage: 2 V

Engine speed: 8001 rpm

Idle speed offset: 139 rpm

Target idle speed: 1825 rpm

Vehicle speed sensor: 0 km/h

Acceleration sensor: -5 m/s²

Engine coolant temperature sensor: 0.10 V

Engine coolant temperature sensor: 52 °C

Intake air temperature sensor: 3.16 V

Intake air temperature sensor: -20 °C

MAP sensor: 0.18 V

MAP sensor: 35 kPa

Accelerator pedal position sensor 1: -- V

Accelerator pedal position sensor 2: -- V

Calculated accelerator pedal position: -- %

Throttle position sensor 1: -- V

Throttle position sensor 2: -- V

Calculated throttle position: -- %

EGR valve: -- V

EGR valve command: -- %

Evaporative emission (EVAP) system, canister purge valve: -- %

Fuel level sensor: -- V

Fuel level sensor: -- V

Fuel level sensor: -- %

Fuel level sensor: -- L

Ignition dwell time: -- ms

Injection time bank 1: -- ms

Ignition angle: -- °

A/C pressure sensor: -- V

A/C pressure sensor: -- kPa

Torque control request (AT): -- N·m

Requested torque (ESP): -- N·m

Knock retard angle cylinder 1: -- °

Knock retard angle cylinder 2: -- °

Knock retard angle cylinder 3: -- °

Knock retard angle cylinder 4: -- °

Short term fuel trim bank 1: -- %

Misfire: --

Long term fuel trim bank 1: -- %

Oil level: --

Engine oil level status: --

Fuel system switch state: --

Thermostat heater control: -- %

Port deactivation position sensor: -- V

Radiator coolant temperature: -- °C

Radiator coolant temperature: -- V

Oil level: --

Engine oil level status: --

Immobilizer

Immobilizer function programmed: No

BCM: vehicle-ID is programmed: Yes

BCM: status of vehicle-ID: Correct

Instrument: vehicle-ID: Yes

Instrument: status of vehicle-ID: Incorrect

Security wait time: Not active

Actuators test

Controls

Power supply relay

Fuel pump relay

Ignition coil

EGR valve

Port deactivation test

Evaporative emission (EVAP) system, canister purge valve

Electronic throttle control (ETC)

A/C relay

Cooling fan relay 1

Cooling fan relay 2

Cooling fan relay 3

Fuel system switch LED test

Check engine telltale

Service vehicle soon telltale

EGR Control

Evaporative emission (EVAP) system, canister purge valve

Electronic throttle control (ETC)

Injectors

Instantaneous tank content control

Utility

Controls

ECU learn reset

Reset O2 loop block learn map

Adjust idle speed

Configuration

Controls

Edit configuration

Edit CAN configuration