Car, OPEL, Corsa C, Combo C, 2003, Z10XE - Motronic ME 1.5.5

VIN no: W0L0XCF6824279303

Part number alpha code: 24443796 AX

Hardware number: BOS 01120261206074

Software number: 1037362740

Software version: 8497

Existing ECU type approval no: B01007

System: Z12XE

Repair shop code or tester serial number:

Programming date: 20 02 05 11

Identifier: 12 11

Vehicle manufacturer specific: 05330301

Vehicle manufacturer specific: 0532

Vehicle manufacturer specific: S 43000102

P1530 [1]: Air conditioner compressor relay - circuit high voltage

Clear DTC

Cooling fan relay 1: Off

Power supply relay: On

Engine oil pressure: Normal

Fuel pump relay: Off

Normal engine operating temperature: Active

Throttle position sensor: Idle

Knock control (B1): Off

O2 sensor 1, bank 1 loop control: Open

EGR valve: Off

Evaporative emission (EVAP) system, canister purge valve: Off

Air/Fuel ratio sensor 1, bank 1: Lean

O2 sensor 1, bank 1 heater: Not active

Air/Fuel ratio sensor 2, bank 1: Lean

O2 sensor 2, bank 1 heater: Not active

Accelerator pedal position at idle position: Active

Idle speed offset: Not active

Check engine telltale: On

Service vehicle soon telltale: On

Electronic throttle control (ETC) limp home mode: Not active

A/C relay: Off

A/C information switch: Off

A/C cut-off mode: Low pressure

Brake pedal switch 2: Off

Clutch pedal switch: Off

Vehicle speed in cruise control range: Not active

Cruise control tip switch: O (Off)

Brake pedal switch 1: Off

Cruise control: Not active

Battery voltage: 12 V

Engine speed: 1000 rpm

Target idle speed: 1150 rpm

Vehicle speed sensor: 0 km/h

Acceleration sensor: 0 m/s²

Engine coolant temperature sensor: 1.51 V

Engine coolant temperature sensor: 70 °C

Intake air temperature sensor: 3.20 V

Intake air temperature sensor: 29 °C

Mass air flow sensor: 1.02 V

Mass air flow sensor: 0 kg/h

Accelerator pedal position sensor 1: 0.96 V

Accelerator pedal position sensor 2: 0.49 V

Calculated accelerator pedal position: 0 %

Throttle position sensor 1: 0.76 V

Throttle position sensor 2: 4.25 V

Calculated throttle position: 5 %

EGR valve: 1.10 V

EGR valve command: 0 %

Evaporative emission (EVAP) system, canister purge valve: 0 %

Fuel level sensor: 2.29 V

Fuel level sensor: 26 L

Ignition dwell time: 2 ms

Injection time bank 1: 0 ms

Ignition angle: -0 °

A/C pressure sensor: 1 V

A/C pressure sensor: 660 kPa

Knock sensor: 0 V

Short term fuel trim bank 1: 0 %

O2 sensor 1, bank 1: 0.451 V

O2 sensor 2, bank 1: 0.000 V

Long term fuel trim bank 1: -1 %

Electronic throttle control (ETC) learn counter: 0

Relative engine load: 25 %

Immobilizer function programmed: Yes

BCM: vehicle-ID is programmed: No

BCM: status of vehicle-ID: Correct

Instrument: vehicle-ID: Yes

Instrument: status of vehicle-ID: Correct

Security wait time: 0:20:00

Fuel pump relay

Ignition coil

EGR valve

Electronic throttle control (ETC)

A/C relay

Cooling fan relay 1

Cooling fan relay 2

Check engine telltale

Cooling fan relay 3

Service vehicle soon telltale

EGR Control

Evaporative emission (EVAP) system, canister purge valve

Electronic throttle control (ETC)

Idle rpm control

Injectors

Compression test

Reset O2 loop block learn map

ECU learn reset

Adjust idle speed

Edit configuration

Edit CAN configuration