Car, OPEL, Vectra B, 1998, X16XEL - Multec (H)

VIN no: W0L0JBF19W1300750

Repair shop code or tester serial number:

Programming date: FF FF FF FF

Hardware number: DEL 0109355289

Part number alpha code: 09364599 DU

Software number: CPCY

Software version: 1

Existing ECU type approval no: D99004

System: X16XEL

Identifier: 09 01

Vehicle manufacturer specific: P1399a01

P1231 [1]: Fuel pump relay contact problem

Clear DTC

MAP sensor: 0.94 V

MAP sensor: 0.28 bar

Battery voltage: 14 V

Intake air temperature sensor: 22 °C

Intake air temperature sensor: 3.67 V

Engine coolant temperature sensor: 2.05 V

Engine coolant temperature sensor: 90 °C

Ignition angle: 6 °

Engine load: 9 %

A/C pressure sensor: 22.20 bar

Knock cell number: 10

Knock retard angle cylinder 1: 0 °

Knock retard angle cylinder 2: 0 °

Knock retard angle cylinder 3: 0 °

Knock retard angle cylinder 4: 0 °

Throttle position sensor: 0.59 V

Throttle position sensor: 0 %

Vehicle speed sensor: 0 km/h

Engine speed: 0.0 rpm

Injection time bank 1: 2 ms

Idle speed actuator: 29 steps

Target idle speed (P-N): 850 rpm

Target idle speed (R-D-3-2-1): 850 rpm

Target idle speed: 850 rpm

O2 sensor 1, bank 1: 0.340 V

O2 integrator: 127 steps

O2 BLM cell number: 18

O2 BLM cell content: 125 steps

Evaporative emission (EVAP) system, canister purge valve: 0 %

Air/Fuel ratio: 15

EGR valve command: 0 %

EGR valve: 0 %

O2 sensor 1, bank 1 loop control: Closed

Full load enrichment: Off

O2 sensor 1, bank 1: Lean

Deceleration fuel cut-off: Off

O2 loop BLM enable: Active

Vehicle speed pulse: Not received

Clear flood mode: Off

Torque control: Not active

Blinkcode request: Not active

P/N switch: R-D-3-2-1 12V

IAC control: On

Fuel pump relay: On

A/C information switch: Off

A/C load signal: Active

Idle adjust: Not modified

Idle adjust drive (R-D-3-2-1): Not modified

A/C relay: Off

Idle adjust P-N: Not modified

A/C coding: Detected

Cooling fan low speed: Off

Cooling fan high speed: Off

Check engine telltale: Off

O2 sensor 1, bank 1 heater: On

EGR valve: 0.68 V

Immobilizer function programmed: Yes

Security wait time: Not active

Fuel pump relay

Ignition coil

EGR valve

Evaporative emission (EVAP) system, canister purge valve

Idle speed actuator

A/C relay

Cooling fan low speed

Cooling fan high speed

Check engine telltale

Injector circuit test

Injectors

EGR Control

Idle rpm control

Idle speed actuator

Reset Idle adjust

Reset knock learn map

Reset O2 loop block learn map

Reset Idle speed actuator learn map

Adjust idle speed drive

Adjust idle speed P-N