Car, OPEL, Vectra C, 2005, Z22SE - GMPT E16

Software version: BM11060B

VIN no: W0L0ZCF6971104579

System identification: DELPH0400

Existing ECU type approval no: G04005

System: Z22SE

Identifier: 05 01

Part number: 13112784

Hardware number: 12563556

Alpha code: TF

U2106 [70]: Lost communication with transmission control module

P1614 [50]: Wrong transponder key

P1616 [0]: Steering column module (CIM) - wrong environment identifier

Clear DTC

Cooling fan relay 1: On

Cooling fan relay 2: On

Cooling fan relay 3: On

Brake pedal switch 2: On

Clutch pedal switch: Active

Vehicle speed in cruise control range: Active

Cruise control tip switch: R (Resume)

Brake pedal switch 1: On

Cruise control: On

A/C relay: On

A/C information switch: Active

A/C cut-off mode: Engine temperature

Oil level: Normal

Engine oil level status: Warning

Engine oil life remaining: 127 %

Engine oil change warning: Active

Ignition status: On

Power supply relay: Off

Fuel pump relay: Off

Normal engine operating temperature: Not active

Full load enrichment: On

Throttle position sensor: Part load

Knock control (B1): Off

O2 sensor loop control bank 1: Closed

Catalyst protection enrichment B1: Active

Evaporative emission (EVAP) system, canister purge valve: On

Air/Fuel ratio sensor 1, bank 1: Rich

O2 sensor 1, bank 1 heater: Off

Air/Fuel ratio sensor 2, bank 1: Rich

O2 sensor 2, bank 1 heater: On

Accelerator pedal position at idle position: Yes

Idle speed offset: Vehicle is moving

Idle speed modified: No

Check engine telltale: Flash

Service vehicle soon telltale: Flash

Electronic throttle control (ETC) limp home mode: Engine stalled

Battery voltage: 23 V

Engine speed: 0 rpm

Target idle speed: 1025 rpm

Vehicle speed sensor: 0 km/h

Engine coolant temperature sensor: 210 °C

Intake air temperature sensor: 215 °C

Outside air temperature: 149 °C

A/C pressure sensor: 5 V

A/C pressure sensor: 40 kPa

Mass air flow sensor: 230 kg/h

MAP sensor: 0.68 V

MAP sensor: 9 kPa

Accelerator pedal position sensor 1: 4.57 V

Accelerator pedal position sensor 2: 0.00 V

Accelerator pedal position 1 fully close learn: 0.00 V

Accelerator pedal position 2 fully close learn: 0.48 V

Calculated accelerator pedal position: 32 %

Throttle position sensor 1: 0.14 V

Throttle position sensor 2: 4.88 V

Throttle position sensor 1 fully close learn: 0.41 V

Throttle position sensor 2 fully close learn: 2.04 V

Calculated throttle position: 74 %

Throttle position PWM servo signal: 100 V

Evaporative emission (EVAP) system, canister purge valve: 14 %

Fuel level sensor: 0.66 V

Fuel level sensor: 9 L

Ignition dwell time: 23 ms

Injection time bank 1: 0 ms

Ignition angle: -64 °

Knock retard angle cylinder 1: 1 °

Knock retard angle cylinder 2: 24 °

Knock retard angle cylinder 3: 255 °

Knock retard angle cylinder 4: 35 °

Short term fuel trim bank 1: 83 %

O2 sensor 1, bank 1: 0.000 V

O2 sensor 2, bank 1: 1.211 V

Delivery mode: Active

Immobilizer function programmed: No

Free start mode: Not active

Security wait time: Invalid

Engine oil life remaining: 127 %

Engine oil change warning: Active

Odometer: 15954 km

Odometer: 9907 miles

Check engine telltale

Reset oil life

Edit VIN

Crank angle sensor learning mode

Edit tire circumference

Edit configuration

Edit CAN configuration