Car, OPEL, Vectra C, 2008, Y20DTH - PSG 16

VIN no: W0L0ZCF6931079803

System identification: BOSCH0100

Software version number: FJCAS370

ECU software version number: 02 5A

Existing ECU type approval no: B02010

System: Y22DTR

Hardware key number: 0000000000

Identifier: 04 10

Part number: 5020109

Alpha code: SR

P0500 [7F]: Vehicle speed sensor 1/A/single range/performance

P1614 [50]: Wrong transponder key

P1616 [0]: Steering column module (CIM) - wrong environment identifier

Clear DTC

Cooling fan relay 1: On

Cooling fan relay 2: On

Cooling fan relay 3: On

Brake pedal switch 2: On

Clutch pedal switch: On

Vehicle speed in cruise control range: Active

Cruise control tip switch: R (Resume)

Brake pedal switch 1: On

Cruise control: On

A/C relay: On

A/C information switch: On

A/C cut-off mode: Engine temperature

P/N switch: P-N

Warm up shift pattern: Active

Torque control: Active

Active driving program: Sport

Torque converter clutch solenoid: Active

Oil level: Normal

Engine oil level status: Warning

Engine oil change warning: Active

Ignition status: On

Engine running signal: Not active

Engine oil pressure: Low pressure

Normal engine operating temperature: Not active

Starter relay: Off

Glow time telltale: On

Glow time relay: Active

Diagnosis glow time relay: Not active

Accelerator pedal position at idle position: Yes

Idle speed offset: Vehicle is moving

Idle speed modified: No

Check engine telltale: Flash

Service vehicle soon telltale: Flash

Electronic throttle control (ETC) limp home mode: Engine stalled

Battery voltage: 23 V

Engine speed: 0 rpm

Target idle speed: 1025 rpm

Acceleration sensor: 5 m/s²

Vehicle speed sensor: 0 km/h

Engine coolant temperature sensor: 0.14 V

Engine coolant temperature sensor: 210 °C

Intake air temperature sensor: 1.00 V

Intake air temperature sensor: 215 °C

Outside air temperature: 149 °C

A/C pressure sensor: 5 V

A/C pressure sensor: 40 kPa

Mass air flow sensor: 0.02 V

Mass air flow sensor: 230 kg/h

Boost pressure sensor: 0.68 V

Boost pressure sensor: 18 kPa

Boost pressure command: 68 kPa

Target mass air flow: 24 kg/h

Accelerator pedal position sensor 1: 4.57 V

Accelerator pedal position sensor 2: 0.00 V

Calculated accelerator pedal position: 32 %

EGR valve command: 0 %

EGR feedback: 24.0 V

EGR valve: 100 %

Evaporative emission (EVAP) system, canister purge valve: 14 %

Fuel level sensor: 0.66 V

Fuel level sensor: 9 L

Pulse ratio throttle control solenoid valve: 92 %

Throttle position sensor: 0.00 V

Torque control request (AT): 24 N·m

Torque control request (TC): 64 N·m

Requested torque (ESP): 162 N·m

Swirl flap - control solenoid: 98 %

Boost pressure solenoid valve - duty cycle: 100 %

Barometric pressure sensor: 4 V

Barometric pressure sensor: 255 kPa

Actual injection quantity: 0 mg/strk

Start of delivery: 12 °

Engine oil temperature sensor: 0 V

Engine oil temperature sensor: -16 °C

Fuel temperature sensor: 4.98 V

Fuel temperature sensor: -5 °C

Injection pump speed: 113 rpm

Delivery mode: Active

Immobilizer function programmed: No

Free start mode: Not active

Security wait time: Not active

Engine oil life remaining: 127 %

Odometer: 62 km

Odometer: 39 miles

Swirl flap - control solenoid

Boost pressure valve

Throttle valve actuator

EGR valve

Glow time relay

Check engine telltale

Glow time telltale

Reset oil life

Compression test

Edit tire circumference

Edit configuration

Edit CAN configuration