Car, NISSAN, Qashqai , DUALIS (J10), 2008-, Europe, PVDOHC - Petrol
PVDOHC - Petrol - 0
Identification
VIN no: SJNFEAJ11U1849437
Manufacturer identification code reprogramming: 22
Supplier number reprogramming: 82 01 03
CRC checksum: 82 01
Part number: CA8CQ
Diagnostic version: 11
Number of reprogramming: 32
DTC
P0830: Clutch switch input - circuit malfunction
P0500: Vehicle speed sensor
Controls
Clear DTC
Data stream
Accelerator pedal position sensor: 0.0 %
Fuel temperature: -49 °C
EGR valve position sensor: 0.0 mV
Battery voltage: 0.00 V
Fuel rail pressure sensor: 0.8 MPa
Fuel rail pressure setting: 0.0 MPa
Mass air flow sensor: 0.0 mg/cp
Air flow demanded: 0.0 mg/cp
Intake manifold pressure: 1698.2 mbar
Boost pressure: 21.2 mbar
Inlet air temperature sensor: -50 °C
Engine speed: 0.0 rpm
Accelerated idle request: Active
Vehicle speed: 5.1 km/h
Immobilizer: Inactive
Severity LED 1: Inactive
Severity LED 2: Inactive
Starting: Inactive
Preheating relay control: Inactive
EGR solenoid valve: Inactive
Fuel flow regulator: Inactive
Fuel pressure regulation: Inactive
Synchronisation: Not done
Engine coolant temperature sensor: -49 °C
Damper valve setpoint position: 0.0 %
Fan assembly: High
Barometric pressure sensor: 870.2 mbar
Fuel flow: 261.1 mg/cp
A/C power consumption: 1720.0 W
Motor: Crank
Computer + after ignition: Not present
Injector 1 commanded ON: Inactive
Injector 2 commanded ON: Active
Injector 3 commanded ON: Active
Injector 4 commanded ON: Inactive
A/C pressure sensor: 0.00 V
Accelerator pedal position sensor 1: 25.0 %
Accelerator pedal position sensor 2: 103.2 %
Fuel pressure solenoid valve: 0.00 V
Fuel temperature sensor: 5.00 V
Mass air flow sensor supply voltage: 0.00 V
Boost pressure sensor: 0.00 V
Air temperature sensor: 2.50 V
INJCTR CONDNSR: 0.00 V
Barometric pressure sensor: 0.00 V
Engine coolant temperature sensor: 0.00 V
Accelerator pedal position sensor 1: 0.00 V
Accelerator pedal position sensor 2: 0.00 V
Fuel flow solenoid valve: 0.8 %
Linearised rail pressure: 7.8 MPa
Cylinder 1 flow corrections: 0.273
Cylinder 3 flow corrections: 0.281
Cylinder 4 flow corrections: 0.008
Cylinder 2 flow corrections: 0.000
EGR valve position recopy: 10.3 %
EGR valve opening reference: 0.0 %
EGR valve last offset: 0.0 mV
EGR valve first offset: 0.0 mV
OBD lamp: Flash
Odometer warning lamp severity 1: 2.1 km
Odometer warning lamp severity 2: 0.0 km
Impact detected: Yes
Accelerator pedal:
Code programmed: Yes
A/C pressure: 34.0 bar
Demand link comp: Inactive
Cooling fan low speed: Active
Cooling fan high speed: Inactive
Brake pedal switch 1: Inactive
Clutch pedal switch: Inactive
Cruise control/speed limiter buttons: Inactive
Cruise control/speed limiter: No detection
Brake pedal switch 2: Inactive
Cruise control/speed limiter deactivation: Not present
Cruise control setting: 0 km/h
CAN diagnostic support monitor
Bus off diagnostic: 0
Transmit diag: 0
VDC/TCS/ABS: 0
Instrument: 0
BCM/SEC: 0
TCM: 0
IPDM E/R: 0
Actuators test
Controls
Fuel flow solenoid valve
Fuel pressure solenoid valve
High pressure fuel circuit leakage
Idle speed increase test
Injectors
Prevention of electrical consumers
Static test of actuators
Turbocharger boost control solenoid valve
Air inlet flap
Preheating relay
Utility
Controls
Edit VIN
EGR adaptives
Programmed values
ECU learn reset
Pressure regulation adaptives
Configuration
Controls
Edit configuration