Car, NISSAN, MURANO (Z52), 2020-, Other market, ICC, ADAS 2
Body control module - ICC/ADAS 2 - 0
Identification
Supplier number reprogramming: 6494334000
Part number: 237619576R
Supplier number: CONT
Calibration number: 64943340000000000000
Hardware number: 237107137R
Software number: 00FE
Edition number: A100
Diagnostic ID: 40
DTC
C1A00: Control module
C1A01: Power supply circuit
Controls
Clear DTC
Data stream
RES/ACC switch: Off
Cancel switch: Off
SET/COAST switch: Off
Cruise operation status: Off
Cruise control switch: main switch: Off
Distance switch: Off
Idle speed position switch: Off
Stop light switch: Off
Brake switch: Off
Set distance: Long
ICC warning: Off
Vehicle ahead detect: Off
Own vehicle: Off
Cruise control lamp: Off
BA WARNING: Off
Vehicle speed sensor: 0 km/h
Set vehicle speed: 0 km/h
Buzzer: Off
Throttle position sensor: 0.0 °
Engine rpm: 0 rpm
Press order: 0.0 bar
Wiper switch: Off
Yaw rate: 0.0 °/sec
Release switch NC: Off
Release switch NO: Off
STP LMP DRIVE: Off
Transmission neutral switch: Off
Position "D" switch status: Off
Parking brake switch: Off
Power supply monitor: 0.00 V
VHCL SPD AT: 0 km/h
Throttle opening: 0.0 %
Gear: 1
Neutral position switch signal: Off
Clutch pedal switch signal: Off
Mode switch signal: Off
SET DISP IND: Off
Distance: 0.0 m
Relative speed: 0.0 m/s
FCW system on: Off
Lane departure warning indicator: Off
LDW on lamp: Off
LDW system on: Off
Side G: 0.0 g
FUNC ITEM (LDW): Off
FUNC ITEM (FCW): Off
FUNC ITEM (BSW): Off
FCW select: Off
BSW select: Off
LDW select: Off
Warning system switch: Off
BSW system on: Off
BSI on indicator: Off
BSW/BSI warning lamp: Off
BCI warning indicator: Off
BCI off indicator: Off
BCI on indicator: Off
BCI high temperature warning indicator: Off
Battery circuit off: Off
System cancel message: Not requested
ITS setting item (LDP): Off
LDW warning indicator: Off
ITS setting item (DCA): Off
LDW on indicator: Off
Front camera unit high temperature message: Off
Side radar block condition: Off
BSW on indicator: Off
BSW indicator brightness: Nothing
BSI warning indicator: Off
ITS setting item (BSI): Off
LDW warning alert timing: Nothing
PMAS indicator: Off
PMAS switch: Off
G sensor signal: 0.00 V
PMAS buzzer req 3: Off
PMAS buzzer req 2: Off
PMAS buzzer req 1: Off
CAN diagnostic support monitor
Bus off diagnostic: 0
Transmit diag: 0
ECM: 0
VDC/TCS/ABS: 0
Instrument: 0
BCM/SEC: 0
ICC/ADAS: 0
TCM: 0
Power steering: 0
EV/HEV system: 0
CAN diagnostic support monitor
Bus off diagnostic: 0
Transmit diag: 0
Actuators test
Controls
EAP switch lamp
Switch lamp
Vibration motor
ADAS buzzer 2
Meter lamp
Brake actuator 1
Brake actuator 2
Brake actuator 3
Utility
Controls
Cause of auto-cancel 2
Cause of auto-cancel 4
Cause of auto-cancel 6
Forward Emergency Braking (FEB) operation distance