Car, NISSAN, LEAF (ZE1), 2022-, Other market, Parktronic

Park pilot - Parktronic - 0

Identification

Supplier number reprogramming: 1270RS353P

Part number: 87A0RS353P

Supplier number: BOSC

Calibration number: ABAAAAAAAAAAAAAAAAAH

Hardware number: 285J91414R

Software number: 1270RS353P

Edition number: SW_ID_1270RS353P_S1.101

Diagnostic ID: 40

DTC

B272D: Front buzzer

Controls

Clear DTC

Data stream

Volume setting: Volume 1

Vehicle speed: 0.0 km/h

ECU power supply: 0.00 V

Sensor voltage: 0.00 V

Detection mode: Mode 1

Sonar permanent Off: No

Reverse range: Off

Sonar temporary Off: No

Trailer connected: Not connected

Switch operation after ignition on: No

LED: Off

P/N range: Off

Shortest distance from rear sensor: 0 cm

Shortest distance from front sensor: 0 cm

Left rear outer distance sensor: 0 cm

CEN[RL]/CEN[R]: 0 cm

Right rear inner distance sensor: 0 cm

Right rear outer distance sensor: -- cm

Left front outer distance sensor: 0 cm

CEN[FL]/CEN[F]: 0 cm

Right front inner distance sensor: 0 cm

Right front outer distance sensor: -- cm

Left rear corner sensor reverberation time: 0.0 ms

Right rear corner sensor reverberation time: 0.0 ms

Left rear center sensor reverberation time: 0.0 ms

Right rear center sensor reverberation time: 0.0 ms

Left front corner sensor reverberation time: 0.0 ms

Right front corner sensor reverberation time: 0.0 ms

Left front center sensor reverberation time: 0.0 ms

Right front center sensor reverberation time: 0.0 ms

Front buzzer: Off

Rear buzzer: Off

Side sensor setting: --

Continuous tone area: -- cm

Discontinuous tone area (near): -- cm

Discontinuous tone area (far) 1: -- cm

Discontinuous tone area (far) 2: -- cm

Timeout for scan zones: -- sec

CAN diagnostic support monitor

Bus off diagnostic: 0

Transmit diag: 0

VDC/TCS/ABS: 0

Instrument: 0

BCM/SEC: 0

ICC/ADAS: 0

HVAC: 0

TCM: 0

Multi AV: 0

Power steering: 0

IPDM E/R: 0

Sonar: 0

AVM: 0

Actuators test

Controls

LED control

Front buzzer

Rear buzzer

Utility

Controls

Volume setting