Car, NISSAN, TIIDA LATIO (SC11), 2005-, Japan, PVDOHC - Petrol
PVDOHC - Petrol - 0
Identification
ECU ID: 00 00
Part number: BA011
Program number: 04 01 01 01
DTC
P1122: Electronic throttle control (ETC) system range/performance
P0118: Engine coolant temperature (ECT) sensor - circuit high voltage
P0227: Accelerator pedal position sensor 2/B - circuit low voltage
P0226: Accelerator pedal position sensor 1/A/single range/performance
P0223: Throttle position sensor (TPS) 1/A/single - circuit high voltage
P1224: Throttle position sensor (TPS) 2/B - circuit high voltage
P1126: Electronic throttle control (ETC) motor relay - circuit open
P1610: Lock mode
P1612: Chain of ECM-IMMU
P1111: Intake camshaft position actuator bank 1 - circuit malfunction
P1065: ECM power supply circuit
P0113: Intake air temperature (IAT) sensor 1/A/single - circuit high voltage
P0444: Evaporative emission (EVAP) system canister purge valve - circuit open
Controls
Clear DTC
Data stream
Engine speed: 1800.0 rpm
Distance since check engine telltale on: 0 km
Mass air flow sensor (Bank1): 0.00 V
Injection time bank 1: 0.0 ms
Injection time bank 2: 0.0 ms
Base injection timing: 0.0 ms
Mass air flow sensor: 0.0 g/sec
Accelerator pedal position sensor 1: 0.00 V
Accelerator pedal position sensor 2: 0.00 V
Throttle position sensor 1: 0.00 V
Throttle position sensor 2: 0.00 V
Fuel correction - lower limit: 0.0 ms
Fuel correction - upper limit: 0.0 ms
Mass air flow sensor - lowest value: 0.00 V
Mass air flow sensor - highest value: 0.00 V
A/C pressure sensor: 0.000 V
A/C signal: Off
Throttle closed position: On
Load signal: Off
Start signal: Off
P/N switch: Off
Power steering signal: Off
O2 sensor 2, bank 2: Lean
O2 sensor 2, bank 1: Lean
O2 sensor 1, bank 2: Lean
O2 sensor 1, bank 1: Lean
A/C relay: Off
Option 1: 0
Option 2: 0
CAN diagnostic support monitor
Bus off diagnostic: 0
IPDM E/R: 3
Readiness test
Catalyst monitoring: Complete
A/C system refrigerant monitoring: Complete
O2 sensor monitoring: Complete
Heated catalyst monitoring: Complete
O2 sensor heater monitoring: Complete
Evaporate system monitoring: Complete
EGR system monitoring: Complete
Secondary air injection system monitoring: Complete
Actuators test
Controls
Fuel injection
Ignition timing
Fuel pump relay
V/T ASSIGN ANGLE
Cylinder power balance
Cooling fan
Utility
Controls
Fuel pressure release
Idle air volume learn
Self-learning cont
Adjust ignition angle
Adjust idle speed
Edit VIN