Bil, NISSAN, TIIDA LATIO (SC11), 2007-, Other market, PVSOHC - Petrol
PVSOHC - Petrol - 0
Identifikation
Stel nr.: SJNFEAJ11U1849437
Manufacturer identification code reprogramming: A
Supplier number reprogramming: RA3
CRC value: 52 41
Dele nummer: RA3CQ
Homologation code: RA3CQ
Number of reprogramming: 41
Fejlkoder
P0830: Clutch switch input - circuit malfunction
P0500: Hastighedsføler
Controls
Clear DTC
Levende Data
Accelerator pedal position sensor: 0.0 %
Accelerator pedal position sensor: 0.0 %
Fuel temperature: -49 °C
Positionsføler for EGR-ventil: 0.0 mV
Batteri spænding: 12.99 V
Trykføler for brændstoffordelerrør: 0.8 MPa
Fuel rail pressure setting: 0.0 MPa
Luft masse måler: 10.0 mg/cp
Air flow demanded: 0.0 mg/cp
Indsugningsmanifoldtryk: 1698.2 mbar
Ladetryk: 21.2 mbar
Inlet air temperature sensor: -50 °C
Exhaust gas temperature before turbocharger: 380.0 °C
Motor Hastighed: 1000.0 Omdr.
Accelerated idle request: Aktiv
Køretøjs hastighed : 0.0 km/h
Startspærre: Inaktiv
Severity LED 1: Inaktiv
Severity LED 2: Inaktiv
Starting: Aktiv
Preheating relay control: Inaktiv
Preheating relay control: Inaktiv
EGR solenoid valve: Inaktiv
Fuel flow regulator: Inaktiv
Fuel pressure regulation: Inaktiv
Synchronisation: Ikke færdig
Motor kølevæske temperatur føler: 70 °C
Damper valve setpoint position: 0.0 %
Fan assembly: Høj
Barometrisk tryk føler: 870.2 mbar
Fuel flow: 261.1 mg/cp
A/C power consumption: 1720.0 W
Motor: Start
Clutch pedal operation: Inaktiv
Computer + after ignition: Ikke tilstede
Injector 1 commanded ON: Inaktiv
Injector 2 commanded ON: Aktiv
Injector 3 commanded ON: Aktiv
Injector 4 commanded ON: Inaktiv
A/C pressure sensor: 0.00 V
Speeder pedal positions føler N1: 0.0 %
Speeder pedal position N2: 0.0 %
Fuel pressure solenoid valve: 0.00 V
Brændstoftemperaturføler: 0.00 V
Mass air flow sensor supply voltage: 0.00 V
Ladetrykføler: 0.00 V
Air temperature sensor: 0.00 V
INJCTR CONDNSR: 0.00 V
Diesel Particulate filter (DPF) differential pressure sensor: 0.00 V
Exhaust gas temperature before turbocharger: 0.00 V
Barometrisk tryk føler: 0.00 V
Motor kølevæske temperatur føler: 0.00 V
Speeder pedal positions føler N1: 0.00 V
Speeder pedal position N2: 0.00 V
Fartpilot: Status 1
Fuel flow solenoid valve: 0.0 %
Linearised rail pressure: 0.0 MPa
Cylinder 1 flow corrections: 0.000
Cylinder 3 flow corrections: 0.000
Cylinder 4 flow corrections: 0.000
Cylinder 2 flow corrections: 0.000
EGR valve position recopy: 0.0 %
EGR valve opening reference: 0.0 %
EGR valve last offset: 0.0 mV
EGR valve first offset: 0.0 mV
OBD lamp: Sluk
Odometer warning lamp severity 1: 100.0 km
Odometer warning lamp severity 2: 100.0 km
Impact detected:
Føler for vand i brændstof: With
Accelerator pedal:
Code programmed: Nej
A/C pressure: 0.0 bar
Demand link comp: Inaktiv
Cooling fan low speed: Inaktiv
Cooling fan high speed: Inaktiv
Brake pedal switch 1: Inaktiv
Koblingspedalkontakt: Inaktiv
Cruise control/speed limiter buttons: Inaktiv
Cruise control/speed limiter: No detection
Brake pedal switch 2: Inaktiv
Cruise control/speed limiter deactivation: Ikke tilstede
Cruise control setting: 0 km/h
CAN diagnostic support monitor
Bus off diagnostic: 0
Transmit diag: 0
VDC/TCS/ABS: 0
Instrument: 0
BCM/SEC: 0
TCM: 0
IPDM E/R: 0
Udgangs test
Controls
A/C compressor relay
Fuel flow solenoid valve
Fuel pressure solenoid valve
High pressure fuel circuit leakage
indsprøjtnings dyser
Prevention of electrical consumers
Static test of actuators
Turbocharger boost control solenoid valve
Air inlet flap
Preheating relay
Muligheder
Controls
Rediger stel nr.
EGR adaptives
Programmed values
ECU learn reset
Pressure regulation adaptives
Konfiguration
Controls
Redigere konfiguration