Bil, MITSUBISHI, COLT CZ3, T (Z30), 2008, Z34A, MNXHL6, ABS, ASC, ASTC, WSS A.S.C.

Bremse system - ABS/ASC/ASTC/WSS A.S.C. - 0

Identifikation

Identificere : 00 02

ECU origin: 04

Supplier number: 03

ECU ID: 00

Diagnose version: 02

Hardware version nummer: 00 01

Softwareversion: 02 03 00

Dele nummer: MN116161

Software nummer: 4670A07200

VIN no (original): XMCXJZ34A8F058114

Class: JZ

Model: Pajero / Montero V8/V9

Type: V98W

Model year: 2007

Stel nr.: JMBLYV98W7J007862

Calibration ID: --

Calibration verification number (CVN): --

Fejlkoder

C1273: Motor drive circuit stuck off

C1266: Motor stuck

Controls

Clear DTC

Levende Data

Højre forhjulshastighedsføler: 0 km/h

Venstre forhjulshastighedsføler: 0 km/h

Højre baghjulshastighedsføler: 0 km/h

Venstre baghjuls hastighedsføler: 0 km/h

Power supply voltage: 11.8 V

Master cylinder pressure: -62.2 bar

Stop light switch: Tænd

Brake switch (input): Sluk

Lateral acceleration sensor: 6.92 m/s²

Steering angle: 0 °

Yaw rate sensor: 568.6 °/sec

Stop light switch: Sluk

Kontakt for bremsevæskeniveau: Tænd

Parking brake switch: Tænd

Brake fluid pressure switch: Sluk

ASC/TCL off switch: Sluk

Valve relay: Tænd

SAS ok flag: Nej

SAS calibration flag: Not completed

Emission test mode: Sluk

Left front inlet solenoid valve: Sluk

Left rear inlet solenoid valve: Sluk

Left front outlet solenoid valve: Sluk

Left rear outlet solenoid valve: Sluk

Right front inlet solenoid valve: Sluk

Right rear inlet solenoid valve: Sluk

Right front outlet solenoid valve: Sluk

Right rear outlet solenoid valve: Sluk

FL/RR diagonal cut valve: Sluk

FR/RL diagonal cut valve: Sluk

FL/RR diagonal booster valve: Sluk

Pump motor: Sluk

FR/RL diagonal booster valve: Sluk

Udgangs test

Controls

Left front wheel ABS drive

Right front wheel ABS drive

Left rear wheel ABS drive

Right rear wheel ABS drive

Left front wheel TCL drive

Right front wheel TCL drive

Left rear wheel TCL drive

Right rear wheel TCL drive

Muligheder

Controls

Rediger stel nr.

Emission gas mode

SAS calibration

Konfiguration

Controls

Redigere konfiguration