Bil, MITSUBISHI, XPANDER (NC), 2019, ND1W, LRQHRV, ABS, ASC, ASTC, WSS A.S.C.

Bremse system - ABS/ASC/ASTC/WSS A.S.C. - 0

Identifikation

Identificere : 00 10

ECU origin: 04

Supplier number: 22

ECU ID: 00

Diagnose version: 10

Hardware version nummer: 07 01

Softwareversion: 07 01 00

Dele nummer: 4670B231

Software nummer: 4670B23100

VIN no (original): --

Class: --

Model: --

Type: --

Model year: --

Stel nr.: --

Calibration ID: --

Calibration verification number (CVN): --

Fejlkoder

C1707: Implausible coding data

C121C: Torque request signal rejection

U0401: Engine (CAN message)

Controls

Clear DTC

Levende Data

Venstre forhjulshastighedsføler: 20.48 km/h

Højre forhjulshastighedsføler: 0.00 km/h

Venstre baghjuls hastighedsføler: 0.68 km/h

Højre baghjulshastighedsføler: 2.73 km/h

Ratvinkelføler: 249.42 °

Yaw rate sensor: -54.28 °/sec

Master cylinder pressure sensor: 40.95 bar

Lateral acceleration sensor: 0.015 G

Acceleration sensor: 1.27 G

Motor Hastighed: 63.5 Omdr.

Motordrejningsmoment: 141.3 N·m

Accelerator pedal position sensor: 59.6 %

Allow ASC torque request: Ikke tilladt

Actual gear: N

Target gear: -

Steering wheel angle sensor offset: -0.17 °

Acceleration sensor offset: -0.002 G

Yaw rate sensor offset: 9.2232 °/sec

Master cylinder pressure offset: 20.4794 bar

Lateral acceleration sensor offset: 0.0170 G

Ignition switch: Tænd

Power supply voltage: -5.0 V

Steering wheel angle sensor calibration: SAS fail & Not Completed

Køretøjs hastighed : 1.5 km/h

Brake switch (input): Sluk

Parking brake switch: Tænd

ASC/TCL mode: Not available

Brake switch: Tænd

ASC/TCL off switch: Tænd

Bremsetrykføler: Tænd

ESS request: Sluk

Emission test mode: Tænd

Udgangs test

Controls

Right front wheel ABS drive

Left front wheel ABS drive

Right rear wheel ABS drive

Left rear wheel ABS drive

Right front wheel TCL drive

Left front wheel TCL drive

Right rear wheel TCL drive

Left rear wheel TCL drive

Engine TCL drive

ESS test mode

Muligheder

Controls

Emission gas mode

Sensor calibration