Bil, MITSUBISHI, TRITON , L200 (KJ, L, K), 2022, KL1T, JLPFPLFB, ABS, ASC, ASTC, WSS A.S.C.
Bremse system - ABS/ASC/ASTC/WSS A.S.C. - 0
Identifikation
Identificere : 00 02
ECU origin: 04
Supplier number: 63
ECU ID: 00
Diagnose version: 02
Hardware version nummer: 00 00
Softwareversion: 30 37 30
Dele nummer: 4670A975
Software nummer: 4670A975
VIN no (original): --
Class: --
Model: --
Type: --
Model year: --
Stel nr.: --
Calibration ID: --
Calibration verification number (CVN): --
Fejlkoder
C1295: Transfer fail
Controls
Clear DTC
Levende Data
Steering angle: 173.6 °
Yaw rate sensor: 66.406 °/sec
Master cylinder pressure: 0.71 MPa
Lateral acceleration sensor: 2.89 G
Longitudinal acceleration sensor: -1.87 G
Motor Hastighed: 546.0 Omdr.
Motordrejningsmoment: 27.3 N·m
Accelerator pedal position sensor: 0.0 %
Allow ASC torque request: Allow
Actual gear: Udefineret
Target gear: -
Højre forhjulshastighedsføler: 5.12 km/h
Venstre forhjulshastighedsføler: 326.40 km/h
Højre baghjulshastighedsføler: 87.04 km/h
Venstre baghjuls hastighedsføler: 26.88 km/h
Power supply voltage: 0.0 V
Parking brake switch: Tænd
Stop light switch: Sluk
Longitudinal acceleration sensor (Raw value): 0.70 G
Lateral acceleration sensor (Raw value): 0.25 G
Steering angle sensor, raw value: 10.7 °
M/C pressure (Raw value): 4.111 MPa
Under cranking: Nej
ASC/TCL off switch: Sluk
Rear differential lock state: Ikke aktiv
Reduction gear state: High gear
Transfer state: Firehjulstræk
Rear differential lock indicator flashing request: Sluk
Reduction gear state (SS4/ES4): -
Rear differential lock state (SS4/ES4): -
Transfer state (SS4/ES4): -
ABS operation status (for ESS): Tænd
ESS request: Sluk
Tire circumference: 10 mm
Udgangs test
Controls
Left front wheel ABS drive
Right front wheel ABS drive
Left rear wheel ABS drive
Right rear wheel ABS drive
Left front wheel TCL drive
Right front wheel TCL drive
Left rear wheel TCL drive
Right rear wheel TCL drive
Engine TCL drive
ESS test mode
Brake light
Muligheder
Controls
Emission gas mode
All sensors calibration
SAS calibration