Car, MITSUBISHI, PHEV (GG), 2019, GG2W, XDHHZLCS, OBC
Power source control - OBC - 0
Identification
Identifier: 00 01
ECU origin: 04
Supplier number: 85
ECU ID: 00
Diagnostic version: 01
Hardware version number: 86 00
Software version: 86 00 04
Part number: 8638A037
Software number: 8637A69600
VIN no (original): --
Class: --
Model: --
Type: --
Model year: --
VIN no: --
Calibration ID: --
Calibration verification number (CVN): --
DTC
U1120: C-CAN bus line low input
Controls
Clear DTC
Data stream
Current charge time: 0 min
Accumulated CHG fail stop count: 23 times
DCDC accumulated active count: 13145 times
DCDC accumulated active time: 508885 min
Current DCDC active time: 7 min
DCDC accumulated fail stop count: 0 times
Accumulated CHG count for 100 V: 28 times
Accumulated CHG count for 200 V: 2944 times
Accumulated CHG time for 100 V: 0 min
Accumulated CHG time for 200 V: 300098 min
Voltage target value: 0.0 V
Current target value: 0.0 A
Power supply voltage: 14.5 V
PFC output voltage: 194 V
Pilot signal (Duty ratio): 0 %
PFC temperature: 12 °C
Inverter temperature 1: 10 °C
Inverter temperature 2: 11 °C
Inside temperature: 14 °C
Power supply voltage (CAN): 14.5 V
On board CHG permit (CAN) flag: Off
EEPROM write status: Complete
Motor/Inverter coolant temperature: 9 °C
Charge start-up req. signal (HW): Lo
S2 switch: Off
Charge flag: Off
Charge start-up req. signal (CAN): Lo
Abnormal stop flag: Off
Cooling request flag: Off
Control power supply req. flag: On
Output limit history (Input voltage): No record
PFC start-up flag: Off
Input current 0 point check: Not accept
Output limit his. (TEMP. trigger): No record
Control mode: Idle
Output limit flag: Off
Current input voltage type: No input
Output limit judge (TEMP.): Off
Output limit judge (Input voltage): Off
Input voltage: 0 V
Input current: 0.0 A
Output voltage: 320 V
Output current: 0.1 A
DCDC power supply voltage: 14.5 V
DCDC inverter temperature 1: 19 °C
DCDC rectification temperature: 13 °C
DCDC inverter temperature 2: 27 °C
DCDC power supply voltage (CAN): 14.5 V
DCDC Motor/Inverter coolant temperature: 9 °C
DCDC drive permission flag: On
DCDC drive flag: On
DCDC fail flag: Off
DCDC output volt target value: 14.70 V
DCDC Input voltage: 322 V
DCDC Input current: 1.2 A
DCDC Output voltage(S terminal): 14.7 V
DCDC Output voltage(B terminal): 14.8 V
DCDC Output current: 28 A