Car, MITSUBISHI, OUTLANDER (GF), 2016, GF8W, XTXPL#, Lane Keep
Speed control - Lane Keep - 0
Identification
Identifier: 00 00
ECU origin: 04
Supplier number: 85
ECU ID: 00
Diagnostic version: 00
Hardware version number: 86 00
Software version: 86 00 04
Part number: 8638A037
Software number: 8637A69600
VIN no (original): --
Class: --
Model: --
Type: --
Model year: --
VIN no: --
Calibration ID: --
Calibration verification number (CVN): --
DTC
U0141: Lost communication with ETACS control module
Controls
Clear DTC
Data stream
ECU power supply: 25.5 V
Light sensor setting: Europe
Rain sensor status: Inactive
Light sensor status: Inactive
Ambient temperature: -38.68 °C
Vehicle speed: 0.1406 km/h
Yaw rate sensor: -327.68 °/sec
Steering wheel angle sensor: Normal
Steering wheel angle sensor: -20520.5 °
IG/Electric motor switch: Lock
Brake switch: Off
Left turn signal lamp: Off
Right turn signal lamp: Off
LDW switch: Off
Rain sensor: Off
Light sensor sensitivity: SNA
Wiper auto stop: Park
Rain sensor sensitivity: Level 1 (Lowest)
LDW Status request: System fail
LDW Indicator request: OFF (Default)
LDW Mode request: Not defined
Wiping stage: Off
Rain sensor information: Ready
Tail lamp: Off
Low beam: Off
Light sensor information: Ready
Tunnel detected: Not detected
Lane Approach Distance (R): 0.25 m
Lane Approach Distance (L): 0.00 m
Lane width: 4.98 m
Lane detection (R): OFF (Default)
Lane detection (L): OFF (Default)
Warning availability (R): OFF (Default)
Warning availability (L): OFF (Default)
Calib. stat.: Camera internal data: No problem dete.
Calib. status: Image adjustment: No problem dete.
Calib.integ.: Camera inter. data: 11 Count
Calib. integ.: Image adjustment: 185 Count
Rain sensor measurement value: 100 Level
Actuators test
Controls
Vehicle speedoff set 65 mode
Warning request output
Standby request output
Temperature fail request output
System fail request output
Utility
Controls
Decalibration: All parameter
Decalibration: Image adjustment
Decalibration: Camera internal data
Calibration: Camera internal data
Calibration: Image adjustment
Stop: Image adjustment