Car, MITSUBISHI, ASX , OUTLANDER , RVR (GA), 2018, GA1W, XNFXL6, ABS, ASC, ASTC, WSS A.S.C.
Brake system - ABS/ASC/ASTC/WSS A.S.C. - 0
Identification
Identifier: 00 10
ECU origin: 04
Supplier number: 22
ECU ID: 00
Diagnostic version: 10
Hardware version number: 07 01
Software version: 07 01 00
Part number: 4670B231
Software number: 4670B23100
VIN no (original): --
Class: --
Model: --
Type: --
Model year: --
VIN no: --
Calibration ID: --
Calibration verification number (CVN): --
DTC
C1707: Implausible coding data
C121C: Torque request signal rejection
U0401: Engine (CAN message)
Controls
Clear DTC
Data stream
Left front wheel speed sensor: 655.35 km/h
Right front wheel speed sensor: 2.55 km/h
Left rear wheel speed sensor: 21.16 km/h
Right rear wheel speed sensor: 1.16 km/h
Steering wheel angle sensor: 155.36 °
Yaw rate sensor: -8.26 °/sec
Master cylinder pressure sensor: 2.23 bar
Lateral acceleration sensor: 0.175 G
Acceleration sensor: -0.06 G
Engine speed: 127.5 rpm
Engine torque: 1.0 N·m
Accelerator pedal position sensor: 16.5 %
Allow ASC torque request: Not allowed
Actual gear: P
Target gear: P
Steering wheel angle sensor offset: 17.85 °
Acceleration sensor offset: 0.020 G
Yaw rate sensor offset: 1.0980 °/sec
Master cylinder pressure offset: 0.0312 bar
Lateral acceleration sensor offset: 0.0255 G
Ignition switch: On
Power supply voltage: 20.5 V
Steering wheel angle sensor calibration: SAS fail
Vehicle speed: 0.1 km/h
ASC/TCL off switch: On
Brake switch (input): On
Power supply voltage (input): 25.5 V
Ignition switch (input): ACC
Parking brake switch: On
ASC/TCL mode: ASC on
Brake switch: Off
Idle stop: Not allowed
Brake pressure sensor: Off
ESS request: Off
Emission test mode: Off
FCM/LDW/AHB: Present
Brake lamp switch: -
FCM engine brake request (FCM/LDW/AHB ECU): Off
FCM auto brake request (FCM/LDW/AHB ECU): Off
FCM brake assist request (FCM/LDW/AHB ECU): Off
FCM target deceleration (FCM/LDW/AHB ECU): -18.05 m/s²
FCM standstill request (FCM/LDW/AHB ECU): Off
FCM brake prefill request (FCM/LDW/AHB ECU): Off
Cruise control off signal: Off
Auto brake active state: Not active
FCM ON/OFF switch: Off
FCM fail state (ASC ECU): Normal
Actuators test
Controls
Right front wheel ABS drive
Left front wheel ABS drive
Right rear wheel ABS drive
Left rear wheel ABS drive
Right front wheel TCL drive
Left front wheel TCL drive
Right rear wheel TCL drive
Left rear wheel TCL drive
Engine TCL drive
ESS test mode
Utility
Controls
Emission gas mode
Sensor calibration