Bil, MITSUBISHI, ASX , OUTLANDER , RVR (GA), 2013, GA2W, XNSHL#, ABS, ASC, ASTC, WSS A.S.C.

Bremse system - ABS/ASC/ASTC/WSS A.S.C. - 0

Identifikation

Identificere : 80 10

ECU origin: 04

Supplier number: 22

ECU ID: 80

Diagnose version: 10

Hardware version nummer: 07 01

Softwareversion: 07 01 00

Dele nummer: 4670B231

Software nummer: 4670B23100

VIN no (original): JMBSNCY2A8U006320

Class: NC

Model: ASX

Type: GA6W

Model year: 2011

Stel nr.: JMBXJGA6WBZ428337

Calibration ID: --

Calibration verification number (CVN): --

Fejlkoder

C1707: Implausible coding data

C121C: Torque request signal rejection

U0401: Engine (CAN message)

Controls

Clear DTC

Levende Data

Venstre forhjulshastighedsføler: 655.35 km/h

Højre forhjulshastighedsføler: 0.06 km/h

Venstre baghjuls hastighedsføler: 0.00 km/h

Højre baghjulshastighedsføler: 0.00 km/h

Steering angle: 1.27 °

Yaw rate sensor: 7.67 °/sec

Master cylinder pressure: 0.15 bar

Lateral acceleration sensor: 0.250 G

Acceleration sensor: -0.06 G

Motor Hastighed: 127.5 Omdr.

Motordrejningsmoment: 1.0 N·m

Accelerator pedal position sensor: 63.5 %

Allow ASC torque request: Allow

Actual gear: P

Target gear: P

Acceleration sensor offset: 0.158 G

Yaw rate sensor offset: -8.8572 °/sec

Master cylinder pressure offset: 0.0938 bar

Lateral acceleration sensor offset: 0.00100 G

Ignition switch: Tænd

Power supply voltage: 12.1 V

SAS ok flag: Not completed

Køretøjs hastighed : 1.3 km/h

ASC/TCL off switch (input): Sluk

Brake switch (input): Sluk

Power supply voltage (input): 0.0 V

Ignition switch (input): Lås

Parking brake switch: Sluk

ASC/TCL off switch: Sluk

Brake switch: Sluk

Bremsetrykføler: Sluk

Emission test mode: Tænd

Brake fluid pressure switch: Lav

Udgangs test

Controls

Left front wheel ABS drive

Right front wheel ABS drive

Left rear wheel ABS drive

Right rear wheel ABS drive

Left front wheel TCL drive

Right front wheel TCL drive

Left rear wheel TCL drive

Right rear wheel TCL drive

Engine TCL drive

Muligheder

Controls

Emission gas mode

Sensor calibration