Car, MITSUBISHI, LANCER (CY, Z0), 2014, CZ4A, SMPFZL#, AT, CVT, A-MT, TC-SST
Transaxle - AT/CVT/A-MT/TC-SST - 0
Identification
Identifier: 00 01
ECU origin: 04
Supplier number: 95
ECU ID: 00
Diagnostic version: 01
Hardware version number: 00 00
Software version: 2B 01 01
Part number: 8631A827
Software number: 8631A8270B
VIN no (original): JMBLMCX4A9U000341
Class: MC
Model: Pajero / Montero V8/V9
Type: V98W
Model year: 2007
VIN no: JMBLYV98W7J007862
Calibration ID: --
Calibration verification number (CVN): --
DTC
P0725: Engine speed signal CAN-bus malfunction
P1792: Loss of torque management signal A
Controls
Clear DTC
Data stream
Engine torque control source: T/M reduction
Brake switch: Off
Parking brake: On
Accelerator pedal position sensor: 0.0 %
Vehicle speed: 254.1 km/h
ABS/ASC operation flag: On
ABS/ASC status: ASC error
Lever position: 1st
Paddle shift switch up (+): Off
Paddle shift switch down (-): Off
Drive mode (Switch input): +
ASC gear hold request: Request (TCL)
AYC gear hold request: On
Left rear wheel speed sensor: 136.5 rpm
Right rear wheel speed sensor: 544.0 rpm
Left front wheel speed sensor: 18.5 rpm
Right front wheel speed sensor: 549.0 rpm
Cold shift request: On
Idle up request: Off
Torque limit by spark retard: Off
Torque increase request flag: On
Torque reduction request flag: Off
Torque limit by throttle closing: On
M/T temperature sensor: 78 °C
M/T temperature warning: On
Drive mode switch: SNA
Gear change mode: Undefined
Current gear: 2nd
Gear display: B Blinking
Target gear: SNA
T/M fail flag: Off
ECU status: Extended session
Current gear (internal data): N
Pre select gear (internal data): R
Gear odd (internal data): 3rd
Gear even (internal data): N
Clutch (odd) temperature: 8191.75 °C
Clutch (even) temperature: 353.75 °C
Clutch (odd) slip speed: -0.5 rpm
Clutch (even) slip speed: -0.5 rpm
Battery voltage: 43.00 V
Clutch (odd) pressure sensor: 256 mbar
Clutch (even) pressure sensor: 7072 mbar
Shift fork position sensor 1: 0.99 mm
Shift fork position sensor 2: 0.31 mm
Shift fork position sensor 3: 8.00 mm
Shift fork position sensor 4: -128.00 mm
Clutch shift pressure solenoid 1: 240 mA
Clutch shift pressure solenoid 2: -2048 mA
Clutch cooling solenoid: -0 mA
Line pressure solenoid: -2048 mA
Input shaft (odd) speed: -1.0 rpm
Input shaft (even) speed: -0.5 rpm
Damper speed sensor: -16384.0 rpm
ECU temperature (internal data): 64.50 °C
Coding counter: 119
Utility
Controls
Plausibility check
Shift fork learn
Line pressure test
Stroke Teach-In
Boost Teach-in
Interlock Teach-In
Clutch ventilation learn
Edit VIN
Configuration
Controls
Edit configuration